Panasonic TH-55LFV70U Operation Instruction Manual

Also see for TH-55LFV70U: Operating instructions Operating instructions Operating instructions

Contents

Panasonic TH-55LFV70U Operation Instruction Manual Manual pdf 45 page image

45SETUPDiaplay ID auto setup J + J J G !!"#+StatusDisplays the implementation status of Display ID auto setup.Operating: the auto setup is in progress." !!"# +{" detected) ? !!"# +Wait: the auto setup has yet to be implemented.Finished: the auto setup has been completed.Display ID Auto SetupStatus WaitDIGITAL LINK daisy chain 1 / 2Display ID 1Network control / IP address OnOff192.168.0.8DIGITAL LINKDIGITAL LINKOff Built-inSerial ID / TerminalSerial out terminalController out terminalController ID / TerminalIR OUTDisplay IDStartChanging network controlChanging serial/IR terminalAutoYesYes!!"# J { A / B ) J = ' J G !!"#+ J ' J G !!"#+Display ID:Displays an ID number obtained by the auto setup.Network control / IP address: ( A / B )A: Displays the disable / enable state of the Network control function.B: Displays the IP address of this display.Serial ID / Terminal: ( A / B )A: Displays the disable / enable state of the ID control function for serial communication.B: Displays which terminal to use for input for serial communication.Serial out:Displays which terminal to use for output for serial communication.Controller ID / Terminal: ( A / B )A: Displays the disable / enable state of the ID control function for remote control operation.B: Displays which sensor / terminal to use for remote control signal input.Controller out terminal:Displays which terminal to use for remote control signal output.Start:Starts the auto setup of a display ID.Display ID: J? J: ' J!!"#+1 ~100 : Sets the origination of the display ID.Changing network control:Sets whether to change the network settings or to retain the current settings as the auto setup of display ID isimplemented.Options: No: retains the settings.| K " ?& +Changing serial/IR terminal:Sets whether to change the control terminal settings for RS232C/IR or to retain the current settings as the autosetup of display ID is implemented.Options: No: retains the settings.| ~ J J!!"#: !!"#' ' =outputterminals of RS232C and controller.Note: For the display connected only input side or output side, the setting of connected side is changed. For the J J!!"#: !!"#' ' = 'RS232C and controller.