Panasonic TH-50PH30E Operating Instructions Manual

Also see for TH-42PH30ER: Product speci?cations Operating instructions

Contents

Panasonic TH-50PH30E Operating Instructions Manual Manual pdf 44 page image

44When Image input and Audio inputdiffer from each other, the Audio inputis displayed as below.Options AdjustmentsSet up the sound when an image input is selected.Image input Audio input[VIDEO] VIDEO / COMPONENT / DVI / PC / NO AUDIO[COMPONENT]* VIDEO / COMPONENT / DVI / PC / NO AUDIO[HDMI] VIDEO / COMPONENT / HDMI / DVI / PC / NO AUDIO[DVI] VIDEO / COMPONENT / DVI / PC / NO AUDIO[PC] VIDEO / COMPONENT / DVI / PC / NO AUDIONO AUDIO: No audio input (Mute)* “COMPONENT”may be displayed as “RGB” depending on the setting of“Component/RGB-in select”. (see page 36)Note:HDMI Audio is selectable only for HDMI Input.Audio input selectPress to select image input.Press to select audio input.Press ACTION ( ) buttonVIDEOAudio input selectCOMPONENTHDMIDVIPC♪ VIDEO♪ COMPONENT♪ HDMI♪ DVI♪ PCPCCOMPONENT16:9OptionsAudio input selectTouch Panel settings1/3Press ACTION ( ) buttonOptionsAudio input selectTouch Panel settings1/3Touch Panel modeCalibration modeTouch Panel settingsOnTouch Panel modeCalibration modeTouch Panel settingsOnThe screen is displayed in the middle and NANODRIFT is deactivated for 180 seconds.After 180 seconds or when you have the menu displayed with a remote control, Calibrationmode is cancelled.Note:For information on how to set up Calibration, please see Touch Panel instructionmanual.The mode to restrict NANODRIFT Saver (see page 29) operation when using Touch Panel (available as an option) is set up.Set “Touch Panel mode” to “On”.Select “Calibration mode” and then press .This setting is used in calibrating a touch panel.You can configure the setting if “Touch Panel mode” is “On”.Calibration modeTouch Panel settings (Settings when using Touch Panel)ªCalibration mode1 select2 adjust1 select2 setNANODRIFT Saver in Touch Panel mode: OnThe value set for NANODRIFT turns into “On” anddisplayed in gray.The moving distance of NANODRIFT is limited to 3 × 3 dotsto prevent pointer drift on a touch panel.When the menu is not displayed (normal screen)Hold down for over 3 seconds.