Panasonic TH-50PH30E Operating Instructions Manual

Also see for TH-42PH30ER: Product speci?cations Operating instructions

Contents

Panasonic TH-50PH30E Operating Instructions Manual Manual pdf 40 page image

H-Freq.V-Freq.kHzHz63.9860.02Signal Format 1280×1024/60SyncSignal [ RGB ]Cinema realityXGA ModeAutoOffAutoHDMI Range AutoH-Freq.Dot Clock Freq.kHzMHz63.98108.0V-Freq. Hz60.02Signal Format 1280×1024/6040This function operates only during input from PC IN terminal.Select Signal from the “Setup” menu during RGB or Component input signal.Setting RGB sync signalConfirm that the input is set to RGB input (this setting is valid only for RGB input signal).Auto: The H and V sync or synchronized signal is automatically selected. If both input, it is selected the H and V sync.on G: Uses a synchronized signal on the Video G signal, which is input from the G connector.Setting Component sync signalConfirm that the input is set to Component input (this setting is valid only for Component input signal).Auto: The H and V sync or synchronized signal is automatically selected. If both input, it is selected the H and V sync.on Y: Uses a synchronized signal on the Video Y signal, which is input from the Y connector.Note:Signals input to COMPONENT/RGB IN terminals correspond to Sync on G or Sync on Y.SyncSetup for Input SignalsPress to select the “Sync”.Press to adjust.Press to select the “HDMI Range”.Press to select “Video(16-235)”, “Full(0-255)”, “Auto”.Displays the frequency and the type of the current input signal.This display is valid only for Component / RGB / PC and Digital input signal.Display range:Horizontal 15 - 110 kHzVertical 48 - 120 HzThe dot clock frequency is displayed during DVI signal input.Switches the dynamic range according to the input signal from HDMI terminal.Input signal displayHDMI RangeVideo(16-235): If the input signal is the video range, Example: HDMI terminal output for DVD playerFull(0-255): If the input signal is full range, Example: HDMI terminal output for personal computerAuto: Switches the dynamic range automatically between “Video(16-235)” and “Full(0-255)” according tothe input signal.Note:This function can be set only for HDMI terminal input.