Panasonic TH-50BT300U Operating Instructions Manual

Also see for TH-42BT300U: Specification Specifications

Contents

Panasonic TH-50BT300U Operating Instructions Manual Manual pdf 44 page image

44SETUP menu3D SETTINGSTo view the 3D images, please adjust and setup the 3D settings.Note:Set these settings for each input terminals.ON3D FUNCTIONAUTO3D INPUT FORMAT3D3D VIEWING MODENORMALLEFT/RIGHT SWAPON3D COLOR COMPENSATION3D SETTINGSSAFETY PRECAUTIONS• 3D FUNCTIONON OFFON: To view the 3D images, please set it to “ON”. You can see 3D images for 3D image signal and 2D images for 2D image signal.OFF: You can see 2D images instead of 3D images.When set to “ON”, “3D” is displayed during 3D images. PCFULLNANODRIFT3D• 3D INPUT FORMAT3D images method is set.AUTO: 3D images are automatically displayed according to the signal.SIDE BY SIDE/TOP AND BOTTOM: One of the formats of the 3D standard. Select these formats as necessary.NATIVE: Displays the input signal as it is. Use to identify the format type of the input signal.SIMULTANEOUS: Set this format when selecting a slot that one of the following terminal boards is installed:Dual HD-SDI Terminal Board for 3D (TY-FB30DHD3D), Dual DVI-D Terminal Board for 3D (TY-FB30DD3D)• 3D VIEWING MODEThe 3D images are separated and displayed as right and left images.3D: Normal 3D images display (initial setting)COMPARISON: Left image (L) and right image (R) are placed side by side. If the 3D system is “TOP AND BOTTOM”,the images are displayed, being set one above the other.LEFT: Only the left image (L) is displayed.RIGHT: Only the right image (R) is displayed.3D COMPARISON LEFT RIGHTNote:• This function is disabled during 2D images.• The factory default setting is “3D”. To view the 3D images, please use “3D”• LEFT/RIGHT SWAPNORMAL SWAPPEDThis function calibrates the timing to switch the right and left images as well as the timing to switch the shutter of right and left 3D Eyewear.Selects “SWAPPED” if you feel that the sense of depth is unusual.• 3D COLOR COMPENSATIONON OFFThe color adjustment during the 3D images is set.ON: The color when using the 3D Eyewear is adjusted. (initial setting)OFF: The color when using the 3D Eyewear is not adjusted. The 2D image setting is used.Note:The factory default setting is “ON”. To view the 3D images, please set it to “ON”.• SAFETY PRECAUTIONSDisplays the precautions for viewing 3D images.2 access1 selectSelect the item and set.2 change1 selectSIGNALMARKER SETTINGSWAVEFORM MONITORSCREENSAVEREXTENDED LIFE SETTINGSFUNCTION BUTTON SETTINGSON/OFF TIMER SETUPDAY/TIME SETUPNETWORK SETUPRGB/MONO SETTINGSCOMPONENT/RGB-IN SELECTRGB3D SETTINGSINPUT LABEL