Panasonic TH-50BT300U Operating Instructions Manual

Also see for TH-42BT300U: Specification Specifications

Contents

Panasonic TH-50BT300U Operating Instructions Manual Manual pdf 42 page image

42SETUP menuPOWER SAVESTANDBY SAVEPC POWER MANAGEMENTDVI-D POWER MANAGEMENTNO SIGNAL POWER OFFNO ACTIVITY POWER OFFOFF ONWhen this function is turned ON, luminous level of the Plasma Display is suppressed, so power consumption isreduced.OFF ONWhen this function is turned ON, power consumption of the microcomputer is reduced during power supply standby(see page 16, 19, 20), so standby power of the set is reduced.DISABLE ENABLEEquipment power supply is turned OFF when there is no signal.When this is set to “ENABLE”, the power supply of the unit goes Off 10 minutes after the input signals stop.DISABLE ENABLEWhen this function is set to “ENABLE”, the power is turned off (standby) automatically when there is no operation of thePlasma Display for 4 hours.Starting from 3 minutes before the turn off, the remaining time will be displayed.When the power is turned off due to this function, a message“LAST TURN OFF DUE TO ’NO ACTIVITY POWER OFF’.” isdisplayed next time the power is turned on.Notes:During the screensaver is running, this function is disabled.OFF ONWhen this function is set to ON, it operates under the following conditions to turn the power on or off automatically.When no pictures (HD/VD sync signals) are detected for 30 or so seconds during PC signal input:Power is turned off (standby); the power indicator lights up orange.When pictures (HD/VD sync signals) are subsequently detected:Power is turned on; the power indicator lights up green.Notes:• This function operates only during PC signal input.• This function is effective when “SYNC” is set to “AUTO”, “COMPONENT / RGB-IN SELECT” is set to “RGB”.OFF ONWhen this function is set to ON, it operates under the following conditions to turn the power on or off automatically.When no pictures (sync signal) are detected for 30 or so seconds during DVI signal input:Power is turned off (standby); the power indicator lights up orange.When pictures (sync signal) are subsequently detected:Power is turned on; the power indicator lights up green.Notes:• This function operates only during DVI signal input.• This function is invalid during input from DVI-D Terminal Board (TY-FB11DD) and Dual DVI-D Terminal Board for 3D(TY-FB30DD3D).• Depending on the type of terminal board equipped, this function may be invalid.NO ACTIVITY POWER OFF 3MINPRESS ANY KEY TO ABORT.