Panasonic TH-42PF50E Operating Instructions Manual

Also see for TH-42PF50E: Operating instructions

Contents

Panasonic TH-42PF50E Operating Instructions Manual Manual pdf 42 page image

42ECO Mode settingsSelect “ECO Mode settings” in “Setup” menu and press button.ECO Mode settingsOffDVI-D Power managementOffPower saveDisableNo signal power offOnStandby saveOffPC Power managementCustomECO Mode 1 select2 adjustECO ModeCustom: The menu of power consumption reduction is individually set.On: The following xed values are set to the menu of power consumption reduction. Individual setting is not available.Power save: Sensor DVI-D Power management: OnStandby save: On No signal power off: EnablePC Power management: OnUsing Remote ControlWhen is pressed, the “ECO Mode” settingchanges.ECO Mode OnCustom settingsThe menu of the power consumption reduction is individually set. This setting is enabled when “ECO Mode” is setto “Custom”.Power saveWhen this function is turned On, luminous level of the Plasma Display is suppressed, so power consumption is reduced.Sensor: The luminous level of the Plasma Display is automatically adjusted according to the viewingenvironment.Standby saveWhen this function is turned On, power consumption of the microcomputer is reduced during power supply standby(see page 15, 18, 19), so standby power of the set is reduced.PC Power managementWhen this function is set to On, it operates under the following conditions to turn the power on or off automatically.When no pictures (HD/VD sync signals) are detected for 30 or so seconds during PC signal input: Power is turned off (standby); the power indicator lights up orange.When pictures (HD/VD sync signals) are subsequently detected: Power is turned on; the power indicator lights up green.Notes:• This function operates only during PC signal input.• This function is effective when “Sync” is set to “Auto”, “Component / RGB-in select” is set to “RGB” and duringnormal viewing.DVI-D Power managementWhen this function is set to On, it operates under the following conditions to turn the power on or off automatically.When no pictures (sync signal) are detected for 30 or so seconds during DVI signal input: Power is turned off (standby); the power indicator lights up orange.When pictures (sync signal) are subsequently detected: Power is turned on; the power indicator lights up green.Notes:• This function operates only during DVI signal input.• This function is invalid during input from DVI-D Terminal Board (TY-FB11DD).• Depending on the type of terminal board equipped, this function may be invalid.No signal power offEquipment power supply is turned Off when there is no signal.When this is set to “Enable”, the power supply of the unit goes Off 10 minutes after the input signals stop.