Panasonic TH-42PF50E Operating Instructions Manual

Also see for TH-42PF50E: Operating instructions

Contents

Panasonic TH-42PF50E Operating Instructions Manual Manual pdf 23 page image

23Troubleshooting for 3D EyewearSymptoms ChecksCannot see 3D images • Has the 3D Eyewear been switched On?• Ensure that “3D Function” in “3D Settings” is set to “On”. (see page 36)• Some 3D image signals may not be automatically recognized as 3Dimages. Set “3D Picture Format” in “3D Settings” to match the pictureformat. (see page 36)• Check if 3D IR TRANSMITTER is turned on and corrected properly.• Check that there are no obstacles between the 3D IR TRANSMITTERand the 3D Eyewear. If the 3D Eyewear stops receiving the infraredsignal for about 5 minutes, the 3D Eyewear will be turned offautomatically.• Check the available area to use the 3D Eyewear.• Depending on the person, the 3D images may be difcult to see,or cannot be seen, especially in users that have a different level ofeyesight between the left and right eyes.Take the necessary steps (wearing glasses etc.) to correct youreyesight before use.3D Eyewear is turned off automatically • Check that there are no obstacles between the 3D IR TRANSMITTERand the 3D Eyewear or that the 3D Eyewear is placed inside thecoverage area. If the 3D Eyewear stops receiving the infrared signalfor about 5 minutes, the 3D Eyewear will be turned off automatically.There is something wrong with the 3Dimages• Switch “Reverse” and “Normal” under “3D Picture Sequence” in “3DSettings” (see page 36).Indicator lamp will not light when the 3Dglasses are turned ON.• The battery may be running low or at. Change the battery or chargethe 3D glasses.Table of images that can be seen for each 3D PictureFormat and the source image formatIf the picture appears to be abnormal, refer to the table below to choose the correct 3D picture format setting.3D Picture FormatSource imageformatAuto Side by Side Top and Bottom NativeSide by side* 1 Normal* 2Top and bottom* 1 Normal*2Normal format(2D) Normal Normal*1 When the source image is not recognized correctly*2 When “3D Function” is set to “On”, the images will be displayed with 3D effect. When set to “Off”, displayedwithout 3D effect.• Depending on the player or contents, the image may be different from the above illustrations.Viewing 3D images