Black extensionGammaInput levelAdvanced settingsNormalNormaliseW/B Low BW/B High RW/B Low RW/B Low GW/B High GW/B High B002.2000000250005PictureNormalNormaliseNormalBrightnessSharpnessPicture ModeColourContrastHueAdvanced settingsWhite balance Normal2812Press to display the Picture menu.Press to select the menu to adjust.Select the desired level by looking at the picture behind the menu.Select to adjust each item.Press “ ” or “ ” button to switch between modes.While the “Picture” menu is displayed, if either the N button on the remote control is pressed at any time or theACTION ( ) button is pressed during “Normalise”, then all adjustment values are returned to the factory settings.Helpful Hint ( / Normalise Normalisation)Note:Menu that cannot be adjusted is grayout. Adjustable menu changes depending on signal,input and menu setting.Picture AdjustmentsPress “ ” or “ ” button to switch between modes.NormalMonitorDynamicCinemaNormalFor viewing in standard (evening lighting) environments.This menu selects the normal levels of Brightnessand Contrast.DynamicFor viewing in brighter environments.This menu selects higher than normal levels ofBrightness and Contrast.CinemaFor use in viewing tone-focused pictures withbrightness reduced.MonitorFor use when creating broadcast or movie content.With this picture, even if the overall average picturelevel (APL) changes, the brightness of areas withthe same signal level does not change.Notes:• When “Monitor” is selected in Picture Mode, thefollowing menu items cannot be set.Extended life settings: Peak limit (see page 40)MULTI DISPLAY Setup menu: Video WallUniformity (see page 47)Portrait Setup menu: Video Wall Uniformity(see page 49)• If you would like to change the picture and colour ofthe selected Picture menu to something else, adjustusing the items in the Picture menu. (see next page)Advanced settingsEnables ne picture adjustment at a professionallevel (see next page).Press to enterAdvanced settings.Normal (9300K) Cool (11500K) Warm (6500K)