Panasonic TH-42PF30U Operating Instructions Manual

Also see for TH-42PF30U: Service manual Operating instructions

Contents

Panasonic TH-42PF30U Operating Instructions Manual Manual pdf 61 page image

61Using Network FunctionThis unit has a network function to control the network connected display with your computer.Note:To use the network function, set each “NETWORK SETUP” setting and make sure to set the “CONTROL I/F SELECT”to “LAN”. (see page 53)When “LAN” is set, the slot power is turned on, and power indicator is lit orange under the condition of power off withremote control (stand-by state), regardless of the “Slot power” setting. (see page 56)Example of Network ConnectionCommand ControlDisplay (main unit, rear)Hub or broadband routerLAN cable(not supplied)Notes:• Make sure the broadband router or hub supports 10BASE-T/100BASE-TX.• To connect a device using 100BASE-TX, use “category 5” LAN cable.• Touching the LAN terminal with a statically charged hand (body) may cause damage due to its discharge.Do not touch the LAN terminal or a metal part of the LAN cable.• For instructions on how to connect, consult your network administrator.Network function of the unit can control the unit in the same way as serial control from a network.Supported commandsCommands used in the serial control are supported. (see page 15)Note:Consult your local Panasonic dealer for detail instructions on command usage.COMPUTERLessthan3.9 inch(10 cm)Lessthan3.9 inch (10 cm)Ferrite core(supplied)Ferrite core(supplied)Installing the Ferrite corePull back the tabs(in two places)Wind the cabletwiceOpenPress the cablethrough and close