Panasonic TH-42PF30U Operating Instructions Manual

Also see for TH-42PF30U: Service manual Operating instructions

Contents

Panasonic TH-42PF30U Operating Instructions Manual Manual pdf 26 page image

00NORMALNORMALIZEAUTO SETUPPOS./SIZEV-POS0H-POSV-SIZEDOT CLOCKH-SIZECLAMP POSITIONCLOCK PHASE1:1 PIXEL MODE OFF000026Adjusting POS./SIZE1 Press to display the POS./SIZE menu.Press to select the menu to adjust.Press to adjust the menu.Press to exit from adjust mode.Notes:• Adjustment details are memorized separately for different input signal formats. (Adjustments for component signals arememorized for 525 (480) / 60i · 60p, 625 (575) / 50i · 50p, 1125 (1080) / 60i · 50i · 60p · 50p · 24p · 25p · 30p · 24sF,1250 (1080) / 50i, 750 (720) / 60p · 50p each, and RGB/PC/Digital signals are memorized for each frequency.)• If a “Cue” or “Rew” signal from a VCR or DVD player is received, the picture position will shift up or down. This pictureposition movement cannot be controlled by the POS./SIZE function.234AUTOSETUPWhen inputting a PC signal as an example, “H-POS/V-POS”, “H-SIZE/V-SIZE”, “DOT CLOCK” and“CLOCK PHASE” are automatically corrected.This setting is enabled under the following conditions:• This setting is not activated during Multiple display, Portrait display or Digital Zoom.• When inputting an analog signal (Component/PC):This setting is enabled if “COMPONENT/RGB-IN SELECT” (see page 49) in SET UP menu is “RGB”.• When inputting a digital signal (HDMI/DVI):A PC format signal enables this setting.When the signal is not PC format, this setting is enabled only if “OVER SCAN” (see page 27) is “OFF” or“1:1 PIXEL MODE” (see page 28) is “ON.” H-SIZE/V-SIZE is not automatically adjusted.This setting will be invalid and will not work under the following conditions:• When VIDEO signal input• Aspect is set to “JUST”• “Display size” in the Options menu (see page 55) is set to “On”Using Remote ControlWhen on the remote control is pressed, “AUTO SETUP” will be executed.When AUTO SETUP does not work, “INVALID” is displayed.Auto modeWhen the “Auto Setup“ is set to “Auto” in the Options menu (see page 56), automatic position adjustment starts :• When the display power is turned ON.• When the input signal is switched.Note:Unadjustable items aregrayed out.Adjustable items differdepending on the input signaland the display mode.