Panasonic TH-42PF30U Operating Instructions Manual

Also see for TH-42PF30U: Service manual Operating instructions

Contents

Panasonic TH-42PF30U Operating Instructions Manual Manual pdf 53 page image

MULTI DISPLAY SETUPSET UP TIMERPRESENT TIME SETUPNETWORK SETUPDISPLAY ORIENTATION LandscapePORTRAIT SETUP2/2SETUP--:--:--:--:--:--DHCPNETWORK SETUPSAVE0192.168. 0. 8255.255.255. 0192.168. 0. 11024AUTORS-232COFFSUBNET MASKLAN SPEEDGATEWAYIP ADDRESSPORTCONTROL I/F SELECTNETWORK IDMAC ADDRESSNetwork SetupMake the various settings to use the network function.DHCP, IP ADDRESS, SUBNET MASK, and GATEWAY settings1 Set DHCP.When “OFF” is selected, IP ADDRESS and other settings can be setmanually.2 Select the item and press .3 Enter an address.I192.168. 0. 8IP ADDRESS1 Use to select a digit.2 Use to change a number.3 Press .Pressing will cancel the address change.4 Select “SAVE” and press .PORT setting1 Select “PORT” and press .2 Enter a port number.I01024PORT1 Use to select a digit.2 Use to change a number.3 Press .Pressing will cancel the port number change.SAVESave the current network Setup. Each value set for DHCP,IP address, Subnet mask, and Gateway will be saved. If“NG” is displayed, check the same IP address is not usedwithin the same network.DHCP (DHCP client function)To obtain an IP address automatically using a DHCP server,set this to “ON”. If DHCP server is not used, set this to“OFF”.IP ADDRESS (IP address display and setting)Enter an IP address if DHCP server is not used.SUBNET MASK (Subnet mask display and setting)Enter a subnet mask if DHCP server is not used.GATEWAY (Gateway address display and setting)Enter a gateway address if DHCP server is not used.PORTSet the port number used for command control.The available setting range is 1024 – 65535.When the PJLink™ protocol is used, the port setting is notnecessary.LAN SPEEDSet the connection speed of the LAN environment.Select the value from AUTO, 10 HALF, 10 FULL,100 HALF or 100 FULL.NETWORK IDSet the ID to identify this unit.The available setting range is 0 – 99.CONTROL I/F SELECTSet whether to control with RS-232C (serial) or LAN. When “LAN”is set, the slot power is turned on, and power indicator is lit orangeunder the condition of power off with remote control (stand-bystate), regardless of the “Slot power” setting. (see page 56)MAC ADDRESSDisplay the MAC address of this unit. However, the MACaddress is not displayed when the “CONTROL I/F SELECT”is set to “RS-232C”.Notes:• To use a DHCP server, make sure the DHCP server is started.• Contact your network administrator for details on settings.53