Panasonic TH-42PF30U Operating Instructions Manual

Also see for TH-42PF30U: Service manual Operating instructions

Contents

Panasonic TH-42PF30U Operating Instructions Manual Manual pdf 42 page image

1/2SIGNALEXTENDED LIFE SETTINGSINPUT LABELSET UPOFFSTANDBY SAVE OFFPC POWER MANAGEMENT ONDVI-D POWER MANAGEMENT OFFOSD LANGUAGE ENGLISH (US)COMPONENT/RGB-IN SELECTRGBSCREENSAVERPOWER SAVE3D SETTINGSNO SIGNAL POWER OFF ENABLENO ACTIVITY POWER OFF DISABLE42Reduces power consumptionPress to select“POWER SAVE”“STANDBY SAVE”“PC POWER MANAGEMENT”“DVI-D POWER MANAGEMENT”“NO SIGNAL POWER OFF”“NO ACTIVITY POWER OFF”.Press to select “ON (ENABLE)” or “OFF (DISABLE)”.On (ENABLE) Off (DISABLE)Press to exit from SET UP.• POWER SAVE: When this function is turned ON, luminous level of the Plasma Display is suppressed, sopower consumption is reduced.• STANDBY SAVE: When this function is turned ON, power consumption of the microcomputer is reduced duringpower supply standby (see page 16, 19, 20), so standby power of the set is reduced.• PC POWER MANAGEMENT: When this function is set to ON, it operates under the following conditions to turn the poweron or off automatically.When no pictures (HD/VD sync signals) are detected for 30 or so seconds during PC signal input:Power is turned off (standby); the power indicator lights up orange.When pictures (HD/VD sync signals) are subsequently detected:Power is turned on; the power indicator lights up green.Notes:• This function operates only during PC signal input.• This function is effective when “SYNC” is set to “AUTO”, “COMPONENT / RGB-IN SELECT”is set to “RGB” and during normal viewing.• DVI-D POWER MANAGEMENT: When this function is set to ON, it operates under the following conditions to turn thepower on or off automatically.When no pictures (sync signal) are detected for 30 or so seconds during DVI signal input:Power is turned off (standby); the power indicator lights up orange.When pictures (sync signal) are subsequently detected:Power is turned on; the power indicator lights up green.Notes:• This function operates only during DVI signal input.• This function is invalid during input from DVI-D Terminal Board (TY-FB11DD) and DualDVI-D Terminal Board for 3D (TY-FB30DD3D).• Depending on the type of terminal board equipped, this function may be invalid.• NO SIGNAL POWER OFF: Equipment power supply is turned OFF when there is no signal.When this is set to “ENABLE”, the power supply of the unit goes Off 10 minutes after theinput signals stop.• NO ACTIVITY POWER OFF: When this function is set to “ENABLE”, the power is turned off (standby) automatically whenthere is no operation of the Plasma Display for 4 hours.Starting from 3 minutes before the turn off, the remaining time will be displayed.When the power is turned off due to this function, a message “LAST TURN OFF DUE TO’NO ACTIVITY POWER OFF’.” is displayed next time the power is turned on.Note:During the screensaver is running, this function is disabled.123NO ACTIVITY POWER OFF 3MINPRESS ANY KEY TO ABORT.