Panasonic TH-42PF30U Operating Instructions Manual

Also see for TH-42PF30U: Service manual Operating instructions

Contents

Panasonic TH-42PF30U Operating Instructions Manual Manual pdf 51 page image

SET UP for Input Signals• SYNCThis function operates only during input from PC IN terminal.Setting RGB sync signalConrm that the input is set to RGB input (this setting is valid only for RGB input signal).AUTO: The H and V sync or synchronized signal is automatically selected. If both input, it is selected the H and V sync.ON G: Uses a synchronized signal on the Video G signal, which is input from the G connector.VBS: Uses a synchronized signal of Composite Sync input, which is input from the HD connector.Setting Component sync signalConrm that the input is set to Component input (this setting is valid only for Component input signal).AUTO: The H and V sync or synchronized signal is automatically selected. If both input, it is selected the H and V sync.ON Y: Uses a synchronized signal on the Video Y signal, which is input from the Y connector.Note:Signals input to COMPONENT/RGB IN terminals correspond to SYNC ON G or SYNC ON Y.• SDI THROUGHSet the active through function of the Dual Link HD-SDI Terminal Board (TY-FB11DHD).OFF ONON: Enables active through.OFF: Disables active through.Note:Settings can only be performed for this menu when a slot mounted with a Dual Link HD-SDI Terminal Board (TY-FB11DHD)is selected.• FRAME CREATIONAutomatically compensates the picture frame rate and removes juddering movements to make the images smooth.OFF MIN* MID MAX* “MIN” can be selected during 2D viewing.Note:Depending on the contents, images may be noisy. To prevent the noise, change the setting.• 3D REFRESH RATEReduces juddering or icker of image due to lighting interference during 3D viewing.100Hz 120HzNote:This setting is disabled when “FRAME CREATION” is set to “OFF”.• HDMI RANGESwitches the dynamic range according to the input signal from HDMI terminal.VIDEO(16-235) FULL(0-255) AUTOVIDEO(16-235): If the input signal is the video range, Example: HDMI terminal output for DVD playerFULL(0-255): If the input signal is full range, Example: HDMI terminal output for personal computerAUTO: Switches the dynamic range automatically between “VIDEO(16-235)” and “FULL(0-255)” according to the input signal.Note:This function can be set only for HDMI signal input.• SDI SIGNAL FORMATThis menu is available only when selecting a slot that the Dual HD-SDI Terminal Board for 3D (TY-FB30DHD3D) isinstalled and set the input signal format for the board.AUTO YCbCr(4:2:2) 10bit YCbCr(4:2:2) 10bit 60p/50p YCbCr(4:4:4) 10bit RGB(4:4:4) 10bitYCbCr(4:2:2) 12bit YCbCr(4:4:4) 12bit RGB(4:4:4) 12bit XYZ(4:4:4) 12bitAUTO: Automatically selects the signal format according to the input signal.51