47OffPortrait SetupSeam hides videoOff1OffAI-synchronizationViewing AreaLocation16 : 9Portrait SetupOffPortrait SetupSeam hides videoOff1OffAI-synchronizationViewing AreaLocation16 : 9Portrait SetupSet up for PortraitPress to exit from adjust mode.7Press to select AI-synchronization.Press to select “Off” , “On”.Adjust to equalize the brightness of the 3 displays when using Portrait setting.The brightness dependson each display’s setting.Equalize the brightnessof all the displays.Off OnNotes:• If you set AI-synchronization to On, the following menus will be unavailable and these settings will be xed to the initialvalues.Picture menu: Colour, Hue, Input level (Advanced settings)• This function cannot be adjusted during input from VIDEO terminal.6Press to select Viewing Area or Location.Press to select each functions.Notes:• For HD signal videos, the “Viewing Area” is set at “16:9”,and cannot be changed.HD signal: 1125(1080) / 60i • 50i • 60p • 50p • 24p • 25p• 30p • 24sF, 750(720) / 60p • 50p, 1250(1080) / 50i• When “Viewing Area” is “16:9”, the aspect mode is set to “16:9”.5Viewing Area: Set a mode of image division for Portrait function.Location: Set a location of image to be displayed for Portrait function.When Portrait Setup is “On”:Display the image of the selected location.When Portrait Setup is “Off”:Represent an area of the selected Location at a normalbrightness and darken the rest of it.Location settingViewing Area and LocationThe mode of image division and the Location by setting of Viewing Area is as follows.Location 1 Location 2 Location 3Location 1 Location 2 Location 3Viewing Area : 4:3Suitable to display 16:9 images. 4:3 imagesextend transversely.Both right and left sides of the image arecut by 48 dots.Viewing Area : 16:94:3 images are displayed without changingaspect ratio.Although the images of each Locationoverlap, you can adjust Pos./Size to displaythe image normally. (see page 25)Undisplayed area (48 dots)Viewing Area / LocationAI-synchronization