Panasonic TH-42PF30ER Operating Instructions Manual

Contents

Panasonic TH-42PF30ER Operating Instructions Manual Manual pdf 41 page image

41Reduces power consumptionPress to select“Power save”“Standby save”“PC Power management”“DVI-D Power management”“No signal power off”“No activity power off”.Press to select “On (Enable)” or “Off (Disable)”.On (Enable) Off (Disable)Press to exit from Setup.• Power save: When this function is turned On, luminous level of the Plasma Display is suppressed, sopower consumption is reduced.• Standby save: When this function is turned On, power consumption of the microcomputer is reducedduring power supply standby (see page 15, 17, 18), so standby power of the set is reduced.• PC Power management: When this function is set to On, it operates under the following conditions to turn the poweron or off automatically.When no pictures (HD/VD sync signals) are detected for 30 or so seconds during PC signalinput: Power is turned off (standby); the power indicator lights up orange.When pictures (HD/VD sync signals) are subsequently detected: Power is turned on; the power indicator lights up green.Notes:• This function operates only during PC signal input.• This function is effective when “Sync” is set to “Auto”, “Component / RGB-in select” is setto “RGB” and during normal viewing.• DVI-D Power management: When this function is set to On, it operates under the following conditions to turn the poweron or off automatically.When no pictures (sync signal) are detected for 30 or so seconds during DVI signal input: Power is turned off (standby); the power indicator lights up orange.When pictures (sync signal) are subsequently detected: Power is turned on; the power indicator lights up green.Notes:• This function operates only during DVI signal input.• This function is invalid during input from DVI-D Terminal Board (TY-FB11DD) and DualDVI-D Terminal Board for 3D (TY-FB30DD3D).• Depending on the type of terminal board equipped, this function may be invalid.• No signal power off: Equipment power supply is turned Off when there is no signal.When this is set to “Enable”, the power supply of the unit goes Off 10 minutes after the inputsignals stop.• No activity power off: When this function is set to “Enable”, the power is turned off (standby) automatically whenthere is no operation of the Plasma Display for 4 hours.Starting from 3 minutes before the turn off, the remaining time will be displayed.No activity power off 3minPress any key to abort.When the power is turned off due to this function, a message “Last turn off due to ’Noactivity power off’.” is displayed next time the power is turned on.Note:During the screensaver is running, this function is disabled.1231/2Signal3D SettingsScreensaverExtended life settingsInput labelOffStandby save OffPC Power management OffNo activity power off EnableOSD Language English (UK)Component/RGB-in selectRGBPower saveSetupNo signal power offDVI-D Power management OffDisable