Panasonic TH-42LFE6E Operating Instructions Manual

Also see for TH-42LFE6E: Operating instructions Service manual

Contents

Panasonic TH-42LFE6E Operating Instructions Manual Manual pdf 46 page image

4646Using Network FunctionPJLink™ ProtocolThe network function of the unit conforms with PJLink™ class 1 and you can operate the following actions from yourcomputer using PJLink™ protocol.• Display setup• Display status querySupported commandsCommands to control the unit with PJLink™ protocol are shown in the table below.PJLink™ security authenticationSet “panasonic” for the PJLink™ password.• PJLink™ is a pending trademark in Japan, the United States, and other countries or areas.Command Control RemarkPOWR Power control Parameter0 = Standby 1 = Power “On”POWR ? Power status query Parameter0 = Standby 1 = Power “On”INPT Input switch ParameterSee the parameter for command INST ?INPT ? Input switch queryAVMT Shutter control Parameter10 = Picture On (picture mute deactivated), 11 = Picture Off (picture on mute)20 = Audio On (audio mute deactivated), 21 = Audio Off (audio on mute)30 = Shutter mode Off (picture and audio mute deactivated)31 = Shutter mode On (picture and audio on mute)AVMT ? Shutter control query Parameter11 = Picture Off (picture on mute)21 = Audio Off (audio on mute)30 = Shutter mode Off (picture and audio mute deactivated)31 = Shutter mode On (picture and audio on mute)ERST ? Error status query ParameterFirst byte: 0Second byte: 0Third byte: 0Fourth byte: 0Fifth byte: 0Sixth byte: Means other error. 0 or 2.Meaning of the 0 – 2 settings:0 = Error is not detected, 2 = ErrorLAMP ? Lamp status query Not supportedINST ? Input switch list query Parameter11: PC IN input (PC)32: DVI-D IN input (DVI)31: HDMI input (HDMI)NAME ? Projector name query Return the Display name contents selected in “Network Setup”.INF1 ? Manufacturer name query Returns “Panasonic”INF2 ? Model name query Returns “42LFE6E” (for 42-inch model)INFO ? Other information query Returns version numberCLSS ? Class information query Returns “1”Command ControlNetwork function of the unit can control the unit in the same way as serial control from a network.Supported commandsCommands used in the serial control are supported. (see page 12)Note:Consult your local Panasonic dealer for detail instructions on command usage.