Panasonic TH-42LFE6E Operating Instructions Manual

Also see for TH-42LFE6E: Operating instructions Service manual

Contents

Panasonic TH-42LFE6E Operating Instructions Manual Manual pdf 41 page image

4141--:--:--:--:--:--DHCPLAN SetupSave0192.168. 0. 8255.255.255. 0192.168. 0. 11024AutoOffSubnet maskDUPLEXGatewayIP addressPortNetwork IDMAC AddressLAN SetupDetailed network settings for the LAN established via the LAN terminal of the Display or twisted pair cabletransmitter can be configured.DHCP, IP address, Subnet mask, and Gateway settings1 Set DHCP.When “Off” is selected, IP address and other settings can be setmanually.2 Select the item and press .3 Enter an address.I192.168. 0. 8IP address1 Use to select a digit.2 Use to change a number.3 Press .Pressing will cancel the address change.4 Select “Save” and press .Port setting1 Select “Port” and press .2 Enter a port number.I01024Port1 Use to select a digit.2 Use to change a number.3 Press .Pressing will cancel the port number change.SaveSave the current network Setup. Each value set forDHCP, IP address, Subnet mask, and Gateway will besaved. If “NG” is displayed, check the same IP addressis not used within the same network.DHCP (DHCP client function)To obtain an IP address automatically using a DHCPserver, set this to “On”. If DHCP server is not used, setthis to “Off”.IP address (IP address display and setting)Enter an IP address if DHCP server is not used.Subnet mask (Subnet mask display and setting)Enter a subnet mask if DHCP server is not used.Gateway (Gateway address display and setting)Enter a gateway address if DHCP server is not used.PortSet the port number used for command control.The available setting range is 1024 – 65535.When the PJLink™ protocol is used, the port setting isnot necessary.DUPLEXSet the connection speed of the LAN environment.Select the value from Auto, 10 Half, 10 Full,100 Half or100 Full.Network IDSet the ID to identify this unit.The available setting range is 0 – 99.MAC AddressDisplay the MAC address of this unit. However, theMAC address is not displayed when the “Control I/FSelect” is set to “RS-232C”.Notes:• To use a DHCP server, make sure the DHCP server is started.• Contact your network administrator for details on settings.Select “LAN Setup” and press .Network Setup