OFF0NORMALNORMALIZEAUTO SETUPPOS. /SIZEV-POS0H-POSV-SIZECLOCK PHASEH-SIZE1:1 PIXEL MODEDOT CLOCK0000Note:Unadjustable items are grayed out.Adjustable items differdepending on the input signaland the display mode.23Adjusting POS. /SIZE1 Press to display the POS. /SIZE menu.Press to select the menu to adjust.Press to adjust the menu.Press to exit from adjust mode.Note:If a “Cue” or “Rew” signal from a VCR or DVD player is received, the picture position will shift up or down. This pictureposition movement cannot be controlled by the POS. /SIZE function.234AUTOSETUPH-POS/V-POS, H-SIZE/V-SIZE, DOT CLOCK and CLOCK PHASE are automatically adjusted when theRGB or PC signal is received.This setting only operates when a PC signal or RGB signal is input, and the aspect is “FULL”.Using Remote ControlWhen on the remote control is pressed, “AUTO SETUP” will be executed.When AUTO SETUP does not work, “INVALID” is displayed.Notes:• AUTO SETUP may not work when a cropped or dark image is input. In such case, switch to a bright imagewith borders and other objects are clearly shown, and then try auto setup again.• Depending on the signal, out of alignment may occur after AUTO SETUP. Carry out ¿ne tuning for theposition/size as required.• If AUTO SETUP cannot set properly for vertical frequency 60Hz XGA signal (1024×768@60Hz and1366×768@60Hz), pre-selecting the individual signal in “XGA MODE” (see page 40) may results in correctAUTO SETUP.• AUTO SETUP does not work well when a signal such as additional information is superimposed out ofvalid image period or intervals between synchronizing and image signals are short.• If AUTO SETUP cannot adjust correctly, select “NORMALIZE” once and press ACTION ( ) then adjustPOS. /SIZE manually.• If the picture goes off screen in the horizontal direction as a result of performing AUTO SETUP, performDOT CLOCK adjustment.