Panasonic TH-103PB1U Operating Instructions Manual

Also see for TH-103PB1E: Operating instructions Service manual

Contents

Panasonic TH-103PB1U Operating Instructions Manual Manual pdf 25 page image

25Clamp Position (During Component/PC input signal)Adjusts the clamp position when black parts of the image have no detail due to underexposureor are tinged with green.Optimum value for Clamp Position adjustmentWhen black parts have no detail due to underexposure (blackout) Value that causes least blackout is the optimum.When black parts are tinged with green Value that cancels the greenishness without causing blackout is the optimum.1:1 Pixel Mode Adjusts the display size when 1125i, 1125p or 1250i signal is input.Notes:• Select On when you would like to replay 1920 × 1080 input signal.• Applicable input signal;1125 (1080) / 50i · 60i · 24sF · 24p · 25p · 30p · 50p · 60p, 1250 (1080) / 50i• Select Off when ickering is shown around the image.• H-Size and V-Size cannot be adjusted when On is selected.Off On1:1 Pixel Mode(2k1k)(For 2k1k signals)When the input signal is a 2k1k signal (2048 × 1080 / 24p, 2048 × 1080 / 24sF), the display sizeis adjusted as follows.Off On (Left) On (Center) On (Right)Note:2k1k signals can only be received when the Dual Link HD-SDI Terminal Board (TY-FB11DHD) is installed.Adjusting Pos./SizeWhile the Pos./Size display is active, if either the N button on the remote control is pressed at any time or the ACTION( ) button is pressed during “Normalise”, then all adjustment values are returned to the factory settings.Helpful Hint ( / Normalise Normalisation)