10 For assistance, please call : 1-800-211-PANA(7262) or, contact us via the web at:http://www.panasonic.com/contactinfo Antenna ConnectionConnect the cable from the Antenna to the VHF/UHF terminalon the unit. Cable ConnectionConnect the cable supplied by your local cable companyto the VHF/UHF terminal on the unit.Overtightening “Nut type” RF coaxial cables may damagejacks. Finger tighten only.• Turn off the power supply for all components before making any connections.• If the cables necessary for connecting a component to the system are not included with the component or available as an option, you may need tofashion a cable to suit the component concerned.• Read the instruction manual for each system component carefully before connecting it.Notes on connectionsConnecting the RF in TerminalNote to CABLE system installer:This reminder is provided to call the CABLE (Cable TV) SystemInstaller’s attention to Article 820-40 of the NEC that providesguidelines for proper grounding and, in partic ular, specifies thatthe cable ground shall be connected to the grounding system ofthe building, as close to the point of cable entry as practical.MixerVHFAntennaUHFAntennaOrCable BoxIn from CABLECAUTIONConnectionsConnects VCRs and other peripheral equipment AV Input terminal 1 is usedConnecting the “1, 2” AV Input TerminalsNotes:• Similar connections are available at the “1, 2” AV input terminals.• AV Input terminal 2 is located on the front of the unit.AudioOUTVideoOUT R L