Panasonic PV 20D53 Operating Instructions Manual

Also see for PV 20D53: Operating instructions

Contents

Panasonic PV 20D53 Operating Instructions Manual Manual pdf 47 page image

4747Advanced Operation*Important: If a remote control button does not work when pressed, press the FM/TV, DVD buttonon the remote and try the button again.• Make settings according to amplifierconnected to optical audio output as shownin above table.*1 When connecting an amplifier (with anoptical digital input connector) whichdoes not contain the Dolby Digital ordts decoder, be sure to select “PCM.”If “Bitstream” is selected, starting DVDplay may cause such a high level of noiseas to be harmful to your ears and damagethe speakers.*2 When a dts decoder is connected, pleaseselect “Bitstream” in “dts.” If “PCM” isselected, there will be stereo sound.AUDIO OUTPUTSelect the digital output to be output from the opticaldigital audio output connector of the unit.Do steps 1 and 2 on page 46.■ “LPCM (DVD)” selectionsOFF: Linear PCM of less than 48 kHz/16 bitis output. When playing DVDs recordedin linear PCM of over 48 kHz/20 bit, nodigital audio is output. (Factory preset)PCM: When playing DVDs recorded inlinear PCM of 48 kHz/20 bit/24 bit ormore, digital audio converted to 44.1kHz/16 bit or 48 kHz/16 bit is output.(Digital output of PCM audio is restrictedto48 kHz/16 bit or below for copyrightprotection.)■ “Dolby Digital” selectionsBitstream: Dolby Digital bitstream (1ch-5.1ch) isoutput. (Factory preset)PCM: When you have connected a amplifierthat doesn’t have a built-in Dolby Digitaldecoder.■ “dts” selectionsBitstream: dts bitstream is output. (Factory preset)PCM: When you have connected a amplifierthat doesn’t have a built-in dts decoder.■ “DRC (Dynamic Range Compression)”selectionsOFF: Normal audio range is selected. (Factorypreset)ON: For dynamic sound even at low volume,this is useful for late-night listening.[Dolby Digital DVDs only].1) Press toselect an item.2) Press SETrepeatedly foroutput. (Seebelow.)1) Press toselect “AUDIOOUTPUT.”2) Press SET todisplay screen.1324 Press ACTION to redisplay DVD MAIN MENUand go to step 2 to setup another item. Or,press ACTION three times to exit.AUDIO OUTPUTSELECT :SET : SETEND : ACTIONLPCM(DVD) : OFFD o l b y D i g i t a l : B i t s t r e a md t s : B i t s t r e a mDRC : OFFDVD MAIN MENUSELECT :SET : SETEND : ACTIONDISC LANGUAGESAUDIO OUTPUTST I L L MODE : AUTOTV MODE : 4:3 Pan & ScanType ofamplifierto beconnectedRecommended settingLPCM(DVD)DolbyDigital dtsNo amplifieris connectedAV amplifierwithout DolbyDigital/dtsdecoderPCM PCM*1 PCM*1AV amplifierincludingDolby DigitaldecoderPCM Bitstream PCMAV amplifierincludingDolbyDigital/dtsdecoderPCM Bitstream Bitstream*2ACTIONSELECTSET