Panasonic PV 20D53 Operating Instructions Manual

Also see for PV 20D53: Operating instructions

Contents

Panasonic PV 20D53 Operating Instructions Manual Manual pdf 10 page image

10 For assistance, please call : 1-800-211-PANA(7262) or send e-mail to : consumerproducts@panasonic.com10Initial Setup (Ready to Play)2 / 6 / 2003 THU 12 : 00 P MDST : ONAUTO C LOCK SETCO MPLETEDSETT I NG : CH 1 0PLEASE SET CLOCK BYPR ESS I NG ACT I ON KEYAUTO C L OCK SETI S I NCO MP L ETEPlug the unit power cord into an ACwall outlet.132• If you use a cable box, turn it on and set it to thePublic Broadcasting Service (PBS) channel in yourtime zone. If you use a DSS receiver, it must beturned off.Initial Setup (Ready to Play)Please make all cable or antenna connections before powering on.Press POWER* on the remote or unit.The unit comes on and auto channeland clock set starts.Settings are made automatically. Whensetup is done, this screen appears.If AUTO CLOCK SET IS INCOMPLETEscreen appears, set the clock using MANUALCLOCK SET procedure on next page.• Function buttons are inoperative during Initial Setup.• Depending on conditions, Auto Clock Set may takelonger than 30 minutes. If so, press STOP to stopsetup and perform settings manually. (See page12-13.)ConnectionsFor ANT./CableConnect the cable from Antenna/Cable tothe VHF/UHF terminal on the unit.For DSS/Cable BoxConnect the OUT jack on your cable boxto the VHF/UHF terminal on the unit witha RF cable.Overtightening “Nut type” RF coaxial cablesmay damage jacks. Finger tighten only.WARNINGNotesPROCEEDINGAUTO CLOCK SETCANCEL : PRESS STOP KEYCH AUTO SET PROCEEDINGIN fromANT./CABLEVHF/UHFVHF/UHFIN fromANT./CABLECable TVConverter BoxVHF/UHFVHF/UHF