1111Initial SetupNote to CABLE system installer:This re mind er is provid ed to call the CABLE(Cable TV) System Installers attention to Article820-40 of the NEC that provides guidelines forproper grounding and, in partic u lar, specifi esthat the cable ground shall be connect ed to theground ing system of the building, as close tothe point of cable entry as practical.THUSET : SETSELECT :END : ACT I O NSET C LOC KDST : O NSE LE C T M ON TH*Important: If a remote control button does not work when pressed, press the FM/TV button onthe remote and try the button again.Manual Clock SetIf AUTO CLOCK SET was incomplete, manuallyset the clock as follows.Press ACTION onthe remote todisplay SETCLOCK Menuscreen.1Press toselect the monthand press SET toset. In the samemanner, selectand set the date,year, time, andDST (DaylightSaving Time).2Press ACTION twice to start CLOCK andexit.3Reset all unit Memory FunctionsWhen moving unit to a new location, or if a mistakewas made in the Initial Setup section.Turn the unit Poweron.1Press and hold both PLAY and on the unitfor more than 5 seconds.• The power will shut off.2Perform “Initial Setup” on page 10.3Unit auto adjusts clock for DST (Daylight SavingTime.)DST (Daylight Saving Time)• If your area does not observe Daylight Saving Time,select DST : OFF (see “Clock” on pages 12 and 13).■ Spring (First Sunday in April)DST: ON ➞ Sets clock ahead one hour.■ Autumn (Last Sunday in October)DST: OFF ➞ Turns clock back one hour.STOPSTOPPOWERACTIONPOWERSELECTSET