Panasonic PN28160K Operation Manual

Also see for PN28080K-ID: Operation manual Operation manual Installation guide

Contents

Panasonic PN28160K Operation Manual Manual pdf 279 page image

279TroubleshootingIf you find any problem, please take the following steps to check.1. LED indicators* The POWER LED is not lit.- Is the power cord connected? Please confirm that the power cord is securely connected to the powerport.* The port LED (left) is not lit in Status mode.- Is the Switching Hub set to Status mode?If the Switching Hub is set to the ECO mode, all LEDs are turned offregardless of terminal connection state.- Is the cable correctly connected to the target port?- Is the cable appropriate to use?- Is each terminal connected to the relevant port conforming with10BASE-T, 100BASE-TX, or 1000BASE-T standard?- Auto-negotiation may have failed. Set the port of this Switching Hub or the terminal to half-duplex mode.* The port LED (right) lights in orange.- A loop has occurred. By removing the loop, orange LED will be turned off.* LOOP HISTORY LED blinks in orange.- This is to notify that there is a port in which a loop is occurring, or has beenremoved within 3 days.2. Communications are slow.* Communications with all ports are impossible or slow.- Are the communication speed and mode settings correct? If the communication mode signal cannot be properly obtained, applyhalf-duplex mode.Switch the communication mode of the connection target tohalf-duplex mode.Do not fix the communication mode of the connected terminal tofull-duplex mode.- Is the link up? If the power saving mode is set to "Full," change it to "Half" or "Disabled."- Is not the utilization ratio of the network to which this Switching Hub isconnected too high? Try separating this Switching Hub from the network.- Doesn't the port LED (right) light in orange? When the port LED (right) lights in orange, the port has been shut downby loop detection function. After removing the loop under this port,wait for the auto-recovery time set in loop detection function, orunblock the port on the configuration screen.

/ 281

Related manuals for Panasonic PN28080K-ID