2394.9.3. System RebootOn the Switch Tools Configuration Menu, pressing "R" opens the SystemReboot Menu, as shown in Fig. 4-9-5. On this screen, you can reboot thisSwitching Hub.Fig. 4-9-5 System RebootScreen DescriptionReboot Status Shows whether or not the reboot command is being executed.Stop Indicates that the reboot command is not beingexecuted.Reboot Type Shows the reboot type. The factory default setting is "Normal."Normal Normal reboot is executed.Factory Default All settings are reset to factory default.Factory DefaultExcept IPAll settings except the IP address are reset tofactory default.Reboot Timer Shows the time between execution of the reboot command andactual reboot. The factory default setting is 0 seconds.Time Left Shows the time left before the system actually reboots afterexecution of the reboot command. A key entry refreshes the screendisplay, allowing you to check the elapsed time.PN28160K Local Management SystemSwitch Tools Configuration -> System Reboot MenuReboot Status: StopReboot Type: NormalReboot Timer: 0 secondsTime Left: N/A-------------------------------- -----------------------------------Set Reboot [O]ptionStart [R]eboot ProcessSet Reboot [T]imer[Q]uit to previous menuCommand>Enter the character in square brackets to select option
