Panasonic VIDEOLARM PCF1 Product Instructions

Panasonic VIDEOLARM PCF1 Product Instructions Manual pdf 1 page image

MODEL: Miniature CameraPCF1, PCV1PRODUCT INSTRUCTIONSSTANDARD INSTALLATION PROCEDUREINCLUDES MODELS: PCF1, PCV1CONTENTS INCLUDE:(1) Housing(1) Weather hood(1) Cover plate(1) Cover plate gasket(1) Allen wrench security head tool(2) Stainless steel 6-32x1/2" captive Security head screws(1) Camera mount bracket(1) Camera bracket arm(1) Bottom mount bracket with PC Board(1) Top mount bracket with camera and lens(2) 4-40 x 1/4" screws(2) Star washers(4) 2-56 x 3/16" screws1. Remove the cover plate by loosening the 2 security headscrews with the security tool.2. If mounting the unit to a wall:A. Remove the 2 Phillips head screws that secure thebottom mount bracket and PC Board to the housing,then remove the bracket. Repeat for the top mountbracket and camera.B. Place the housing face down on a flat surface and usea hammer to remove the knockout located at thecenter of the back of the housing.C. Use the 2 mounting holes and the appropriatehardware (not included)to secure the housing to thewall.3. If mounting the unit on a pedestal:NOTE: 3/4" conduit with a threaded end is required for thismethod of installation.A. Install the conduit in the desired location; run thewiring through the conduit.B. Place the PFC1/PCV1 housing onto the conduit, feedthe wires through the bottom hole and thread thehousing onto the conduit until tight.N NOTE: Apply silicone sealant to the conduit threads andthe hole plug to ensure a water tight seal.4. Make the necessary connections to the PC Board andreattach the bottom bracket to the housing.Top mount bracket and cameraBottom mount bracket and PC BoardUSE CLASS 2 POWER ONLY!5. Hand place the top bracket and camera into the unit.Check the angle of the camera, remove the bracket/camera and make any necessary adjustments. Onceyou have achieved the desired camera angle, reattachthe top bracket and camera to the housing.6. Fine focusing (see diagram below):Fixed Lens: Manually rotate the lens until a clear picture isachieved.Vari-Focal Lens: First, adjust the Magnification Lock Screwto the desired magnification (telephototo wide angle). Tighten the Lock Screw.Next, adjust the Focus Lock Screw until aclear picture is achieved. Tighten theLock Screw.Fixed Lens Camera(PCF1)Vari-focal Lens Camera(PCV1)Manual focusFocus Lock ScrewMagnificationLock ScrewCamera Fine FocusManufactured by:forBefore attempting to connect or operate this product, please read these instructions completely.81-IN3046-9922DESCRIPTION: Outdoor Pedestal Mount Housing,Color Camera

/ 3

Related manuals for Panasonic VIDEOLARM PCF1