Panasonic PCF2 Product Instructions

Panasonic PCF2 Product Instructions Manual pdf 2 page image

- 2 -DOME REPLACEMENT1. Rotate the liner inside the dome, so that when the dome issecured to the base, the camera lens is in the center of theviewing slot of the liner.NOTE: It may be helpful to install the dome without the linerthe first time. This way you can visually determinewhich direction the lens is pointing and adjust the lineropening accordingly.2. Align and insert the three tabs of the dome with the three tabslots on the dome base. Rotate the dome clockwise until thedome locks into place.CAMERA ADJUSTMENT1. Clip the tabs of the template onto the swivel plate so that thetemplate is attached to the swivel plate.2. Loosen the two 4-40 Phillips head screws, adjust the camera tothe desired position, and tighten the screws.Note: Adjust camera lens as close as possible to the outline ofthe bottom of the template.Camera swivel plateCamera AdjustmentArmCamera Mount withCamera and PC BoardLoosen screws to adjust cameraTabTabPlace the lens as close tothis edge as possibleCamera Adjustment TemplateLinerDomeTabsBase3. Fine focusing (see diagram below):Fixed Lens: Manually rotate the lens until a clear picture isachieved.Vari-Focal Lens: First, adjust the Magnification Lock Screwto the desired magnification (telephototo wide angle). Tighten the Lock Screw.Next, adjust the Focus Lock Screw until aclear picture is achieved. Tighten theLock Screw.Fixed Lens Camera(PCF2, PCF6)Vari-Focal Lens Camera(PCV2, PCV6)Manual focusFocus Lock Screw MagnificationLock ScrewVideoBNC ConnectorsPower ConnectionsNOTE: Splice wiring according tostandard electrical guidlines.Positive and Negative connections areinterchangeable with this PC Board.Connections

/ 5

Related manuals for Panasonic PCF2