Panasonic KX-TG9581 Operating Instructions Manual

Contents

Link to cell settingsSelecting which unit receives cellularcallsYou can select which unit rings and receives callsfor a cellular line. When “All” is selected, allhandsets and the base unit ring.Program this setting using either the base unit orone of the handsets.Handset / Base unit1 For CELL 1: MMENUN#6271For CELL 2: MMENUN#6272For CELL 3: MMENUN#6273For CELL 4: MMENUN#62742 MbN: Select the desired handset or “All”. aMSAVEN3 Proceed with the operation for your unit.Handset: MOFFNBase unit: MEXITNNote:R When you select a specific handset to receivecalls for a cellular line:– other handsets cannot answer the calls.– the base unit can answer the calls eventhough it does not ring. However, you canmake the base unit ring by adjusting the baseunit ringer volume (page 45).R When you change to “All” from other setting,the base unit ringer volume also returns to thelowest level even if the ringer volume waschanged.R The units selected with this setting have the textmessage alert feature (page 58) applied tothem.Ring as cell modeOnce this feature is turned on, the handset andbase unit ring using the same ringer tone as yourcellular phone.The following settings are available:– “Off”: Turn this feature off to use the ringertones of the handset and base unit. Callerinformation is announced depending on theTalking Caller ID setting (page 47).– “On (with Talking CID)” (default): Thehandset and base unit use your cellular phone’sringer tone. Caller information is announcedeven if the Talking Caller ID is turned off.– “On (without Talking CID)”: Thehandset and base unit use your cellular phone’sringer tone. Caller information is not announcedeven if the Talking Caller ID is turned on.Program this setting using either the base unit orone of the handsets.Important:R To use this feature, your cellular phone mustsupport Bluetooth in-band ringtone. Refer toyour cellular phone’s operating instructions.Handset / Base unit1 For CELL 1: MMENUN#6141For CELL 2: MMENUN#6142For CELL 3: MMENUN#6143For CELL 4: MMENUN#61442 MbN: Select the desired setting. a MSAVEN3 Proceed with the operation for your unit.Handset: MOFFNBase unit: MEXITNNote:R The units use the preset ringer tones(page 46) instead of your cellular phone’sringer tone when a cellular call is being receivedif:– your cellular phone is in silent mode(depending on your cellular phone).– the base unit is in use.– 2 handsets are sharing a landline call.R If your cellular phone is in silent mode with “On(with Talking CID)” set, the unitannounces caller information even when TalkingCaller ID is turned off (page 47).To use the handset ringer tone instead of yourcellular phone’s ringer toneSelect “Off” in step 2, “Ring as cell mode”,page 20.To change the handset ringer tone for a cellularline, see page 45.Auto connection to the Bluetoothdevices (cellular phones or headset)After pairing, your Bluetooth devices areconnected to the base unit. If you move theBluetooth devices out of base unit range, theBluetooth devices are disconnected from the base20 For assistance, please visit http://www.panasonic.com/helpLink to CellTG958x_0704_ver031.pdf 20 2014/07/04 10:32:25