To connect to 2 single-line telephone jacksExample: DSL/ADSL line is line 2Connect the “Transparent” plug telephone linecord (2-wire cord) (1 ) to the unit, then to thesingle-line telephone jack (RJ11C) (2 ) untilyou hear a click.Connect the “GREEN” plug telephone linecord (4-wire cord) (3 ) to a DSL/ADSL filter(not supplied) (4 ), then to the single-linetelephone jack (RJ11C) (5 ) until you hear aclick.25431 21“Transparent” plug“GREEN”plug*DSL/ADSL filter (not supplied) is required if youhave DSL/ADSL service.Handset battery installationR USE ONLY rechargeable Ni-MH batteries AAA(R03) size (1 ).R Do NOT use Alkaline/Manganese/Ni-Cdbatteries.R Confirm correct polarities ( , ).1R Follow the directions on the display to set upthe unit.Handset battery chargingCharge for about 7 hours.R Confirm “Charging” is displayed (1 ).R When the batteries are fully charged, “Fullycharged” is displayed.1Handset battery levelIcon Battery levelHighMediumLowNeeds charging.EmptyPanasonic Ni-MH battery performance(supplied batteries)Operation Operating timeIn continuous use 15 hours max.*1Not in use (standby) 7 days max.*1*1 If eco mode is on.Note:R Actual battery performance depends on usageand ambient environment.12 For assistance, please visit http://www.panasonic.com/helpGetting StartedTG958x_0704_ver031.pdf 12 2014/07/04 10:32:24