8.1 Troubleshooting — KX-TDA30Installation Manual 4098.1.4 Using the Reset ButtonIf the Hybrid IP-PBX does not operate properly, use the Reset Button. Before using the ResetButton, try the system feature again to confirm whether there definitely is a problem or not.Notes1. When the System Initialise Switch is set to "NORMAL", pressing the Reset Buttoncauses the following:• Camp-on is cleared.• Calls on hold are terminated.• Calls on exclusive hold are terminated.• Calls in progress are terminated.• Call park is cleared.Other data stored in memory, except the above, are not cleared.2. When the System Initialise Switch is set to the "SYSTEM INITIALIZE" position, youmust press the Reset Button with caution, because all data stored in memory will becleared by the following operation: (1) pressing the Reset Button and then, (2) settingthe System Initialise Switch to the "NORMAL" position while the RUN indicator isflashing (within approximately 10 s).Operation1. If the Hybrid IP-PBX does not operate properly:a. Make sure that the System Initialise Switch is set to the "NORMAL" position.b. Press the Reset Button.2. If the Hybrid IP-PBX still does not operate properly:a. Set the System Initialise Switch to the "SYSTEM INITIALIZE" position.b. Press the Reset Button.c. Return the System Initialise Switch to the "NORMAL" position while the RUN indicatoris flashing (within approximately 10 s).NoteAs a result of Step 2, all the programmed data will be cleared.Reset ButtonSystem Initialise SwitchRUN IndicatorALARM Indicator
