12.3 [10-3] DID TableIncoming CO line calls with DID numbers can be distributed to specific destinations. Each DID number has adestination programmed for each time mode (day/lunch/break/night).When CLI distribution is enabled for a DID number, incoming CO line calls with that DID number will bedistributed to the CLI destinations (instead of the DID destinations) if the caller’s identification number is foundin the System Speed Dialing Table, which is used as the Caller ID Table. CLI distribution can be enabled ordisabled for each time mode (day/lunch/break/night) on a DID number basis.A maximum of 1000 DID numbers can be programmed with other related parameters. 100 numbers aredisplayed at a time. To display other sets of numbers, click the applicable tab.To assign DID destination numbers, enter directly or click Destination Setting (see 2.1.6 Extension NumberSetting). It is possible to program DID numbers and DID destinations in each time mode (day/lunch/break/night) for a set of locations in series at once by clicking Automatic Registration, or to program DID namesfor a set of locations in series at once by clicking Name Generate.DID NumberSpecifies the DID number.DefaultNot stored.Value RangeMax. 32 digits (consisting of 0–9, *, and #)Maintenance Console Location12.3 [10-3] DID TableProgramming Manual References12.4 [10-3] DID Table—Automatic RegistrationFeature Manual References4.1.6 DID (Direct Inward Dialing)DID NameSpecifies the name for the DID number which is shown on the extension’s display when receiving a call withthe DID number. The name of the DID number can be printed out on SMDR.DefaultNot stored.Value RangeMax. 20 charactersMaintenance Console Location12.3 [10-3] DID TableDocument Version 2009-12 PC Programming Manual 79712.3 [10-3] DID Table
