This option allows direct entry of connection parameters, for cases where the PC is used to connect to one orjust a few PBXs, and an individual profile for each PBX is not necessary. If you connect to multiple PBXs andwould prefer to choose from among pre-saved profiles instead, see 2.2.7 Program launcher—Connect—Profile Setup for more details about creating profiles.To connect to the PBX by LAN1. From the program launcher, select Connect.The Login window will be displayed.2. Select a connection option.• Select a Profile Name if you want to use a pre-saved profile.a. Select the profile to use from the drop-down list.b. If the system password for the PBX has not been stored with the profile, enter it.If the system password has been stored with the selected profile, it does not need to be entered.• To enter the parameters manually, select the PBX Model and confirm that the LAN radio button isselected.a. Specify the connection parameters as required. For more details, see the table below.b. Enter the system password for the PBX.3. Click Connect.Connection Settings for LANSetting Values ExplanationIP Address 1.0.0.0–223.255.255.255Specify the IP address of the PBX on theLAN. Enter the same IP address that wasinput in IP Address for IPCMPR Card of3.4 [1-1] Slot—Card Property - IPCMPR.Port Number 1–65535 Specify the port number used to access thePBX via LAN. Enter the same port numberthat was input in Maintenance PortNumber of 3.4 [1-1] Slot—Card Property -IPCMPR.2.2.6 Program launcher—Connect—ModemConnects to the PBX in Interactive mode through the modem.To access the PBX remotely using this feature, an RMT card must be installed and the Remote—AnalogRemote (Modem) Floating Extension Number assigned in 13.1 [11-1] Main.This option allows direct entry of connection parameters, for cases where the PC is used to connect to one orjust a few PBXs, and an individual profile for each PBX is not necessary. If you connect to multiple PBXs andwould prefer to choose from among pre-saved profiles instead, see 2.2.7 Program launcher—Connect—Profile Setup for more details about creating profiles.To connect to the PBX by Modem1. From the program launcher, select Connect.The Login window will be displayed.2. Select a connection option.Select a Profile Name if you want to use a pre-saved profile.a. Select the profile to use from the drop-down list.b. If the system password for the PBX has not been stored with the profile, enter it.If the system password has been stored with the selected profile, it does not need to be entered.32 PC Programming Manual Document Version 2009-122.2.6 Program launcher—Connect—Modem
