Pre Installation Information17Getting to KnowYour MachineTo install your machine as SMTP mail server, the following network parameters need to be programmed onyour network and on your machine.• IP Address of the DNS Server (if not available, see Note 2)• IP Address of your machine• Subnet Mask of your machine• Name or IP Address of the Default SMTP mail server• IP Address of the Default Gateway• Email Address of your machine (see Note 1)• Host Name• SMTP Authentication Name (when authentication with the SMTP server is required)• SMTP Authentication Password (when authentication with the SMTP server is required)Email (from your machine to a PC) and Direct IFAX XMT TransmissionEmail (from a PC to your machine) and Direct IFAX XMT ReceptionNOTE 1. To function as SMTP mail server, your machine's email address must include its unique Hostname within your company domain. This unique Host name must be registered within yournetwork’s DNS (Domain Name System) server. Example: Internet_Fax@fax01.panasonic.com2. By default the machine requires the IP Address of the DNS Server and prompts you to enterthe SMTP Server Name. If the DNS Server is not available, change the Fax Parameter No.161 (DNS SERVER) to "1:Invalid". Then the machine will prompt you to enter the IP Addressof the SMTP Server.Setup as SMTP Mail Serverifaxuser@fax01.panasonic.comSMTP01.panasonic.com(SMTP Mail Server)POP02.panasonic.com(POP Server)Router(Gateway)popuser001@panasonic.comSMTPPOP3Direct IFAX XMTifaxuser@fax02.panasonic.comifaxuser@fax01.panasonic.comSMTP01.panasonic.com(SMTP Mail Server)Router(Gateway)popuser001@panasonic.comSMTPDirect IFAX XMTifaxuser@fax02.panasonic.com
