Panasonic DMR-UBT1 Operating Instructions Manual

Also see for DMR-UBT1: Operating instructions Operating instructions

Panasonic DMR-UBT1 Operating Instructions Manual Manual pdf 25 page image

RecordingTQBS0146 25RecordingTV programmesThis unit can record two programmes beingbroadcasted at the same time.To record two programmes simultaneouslyWhile recording, perform steps 1–3 (> above).• Channel can only be switched between the recordingprogrammes.• If a timer recording reaches its start time when all tunersare being used for recording, the recording (OTR) of one ofthe programmes terminates.• Copying cannot be performed while recording.• When “Automatic Standby after OTR” is set to “On”. (> 79)1 Select “Recording Time” or “Continuousrecording” in step 3 (> above).Recording Time:You can set the length of recording time from30 minutes to 4 hours.• You can select the recording time with [2, 1].2 Press [OK].This unit can record programmes in DR mode andthen automatically change their recording mode(picture quality) to another setting while instandby mode.1 Press [OPTION].2 Select “Recording Mode”.3 Select the recording mode (picture quality),then press [OK].• Recording mode (Picture Quality) (> 19)• The recording mode set here is used asthe default value for the next recording.To change the recording mode after recordingin DR mode (> 48, “Picture Quality Change”)To check to see if the recording mode changeis finished (> 49)To cancel the recording mode change (> 49)• Programmes in the original picture quality (DR mode) will bedeleted after their recording mode is changed.• It takes about the same amount of time as recording tochange the recording mode.• When the HDD does not have enough remaining space, therecording mode change function does not operate.• A recording mode change stops when this unit is turned on.The process will start from the beginning again after the unitis switched to standby mode.• Even if you change the recording mode of a programme, itsaudio, subtitle settings will remain the same as those at thestart of recording.PreparationIf you want to change the recording mode (picturequality) (> right)1 Select the channel to record.2 Press [REC ¥].Recording will start.3 Select “Automatic Stop”, then press [OK].• One touch recording (OTR)Recording stops automatically when theprogramme ends.To set the recording timeRecordingAutomatic Stop at XXXXXREC1/OTRRecording TimeContinuous recording30 minXXXXX - XXXXXTo change the recording mode (picture quality)HGHXHEHLHMXPSPLPDR(Original)Recording Mode ( Picture Quality )OKRETURNHDD Remain (DR)mhHighDefinitionStandardDefinition