Panasonic DMP-BDT460 Owner's Manual

Also see for DMP-BDT360: Operating instructions Operating instructions Basic operating instructions

Panasonic DMP-BDT460 Owner's Manual Manual pdf 33 page image

33SQT0080ReferenceCannot play.¾ You inserted an incompatible disc (Discsrecorded in PAL video, etc.).Cannot display on this unit.¾ You tried to play a non-compatible image.¾ Re-insert the media.No disc inserted.¾ The disc may be upside down.$ This operation is not available.¾ Some operations are unsupported by the unit.(For example, reverse slow motion, etc.)IP address is not set.¾ The “IP Address” in “IP Address/DNSSettings” is “---. ---. ---. ---”. Set the “IPAddress”, “Subnet Mask”, and “DefaultGateway”. (Select the automatic addressacquisition if necessary.)The current wireless network security settingis weak. It is recommended to change to astronger security setting.¾ Set a stronger network security level referringto the wireless router owner’s manuals.NET¾ While connecting to a network.No PLAY¾ There is a viewing restriction on a BD-Videoor DVD-Video. (> 27)¾ The media is dirty or badly scratched. Theunit cannot play.REMOVE¾ The USB device is drawing too much power.Remove the USB device.SET (“ ” stands for a number.)¾ The remote control and this unit are usingdifferent codes. Change the code on theremote control.Press and hold [OK] and theindicated number button atthe same time for more than5 seconds.U59¾ Temperature of this unit is hot and the unitswitches to standby for safety reasons.Wait for about 30 minutes.Install or place this unit with good ventilation.H or F(“ ” stands for a number.)¾ There is something unusual.¾ Check the unit using the troubleshootingguide. If the service number remainsdisplayed, do the following.1 Disconnect the plug from the AC outlet, wait afew seconds, then reconnect it.2 Press [Í/I] to turn the unit on.If the service number remains displayed despitedoing the above, request service from the dealer.Inform the dealer of the service number whenrequesting service.START¾ The system is being restarted during thefirmware update. Please do not turn off theunit.UPD/(“ ” stands for a number.)¾ The firmware is being updated.Please do not turn off the unit.FIN¾ The firmware update is complete.Messages on the screenMessages on the unit’sdisplay