Panasonic CT10R11 Operating Instructions Manual

Contents

Panasonic CT10R11 Operating Instructions Manual Manual pdf 5 page image

Antenna ConnectionHow to Install VHF/UHF Rod AntennaA VHF/UHF rod antenna is supplied.Push the stem of the VHF/UHF antenna into the antenna hole on the cabinet back as shown.Extend the antenna and adjust its length, direction and angle for the clearest picture.Outdoor VHF/UHF Antenna - Reception is best with a properly installed outdoor antenna, particularly in weak signalareas. Contact your Dealer or Service Technician for recommendations of antennas best suited for your area whenrequired. Connect antenna as shown in one of the drawings.Cable TV ConnectionYou are capable of receiving channels from general types of cable TV systems. Certain cable systems offset somechannels to reduce interference or have Premium (scrambled) channels, so a cable converter box is required. To ensureproper installation and reception, check with your local cable company for its compatibility requirements.Antenna Connections Using CombinedVHF & UHF 75 Ohm Lead CableVHF/UHF Rod Antenna(An optional 75 Ohm outdoorVHF/UHF antenna may be used).CATV (Cable) Antenna ConnectionTo CATVANT AntennaCableBACK OF SETPlace stem of antennahere when using anoptional swivel mount.Antenna Connection Using Individual VHF &UHF Flat 300 Ohm Twin Lead CablesANTSplitter/Combiner(Not Supplied)Twin Lead CableOther Video AccessoriesVCRs, Video Disc Players, Computers, TV games, and Teletext equipment can also be connected to the antennaconnection.Remote Control Battery Installation & ReplacementBattery InstallationBatteries: Use two "AA" dry cell batteries as supplied.2. Slide Forward1. Press CoverTurn the transmitter upsidedown. To open cover, pressdown and slide forward.Two AA" size 1attedes2. Install the batteries as shownin the battery compartment.(Polarity (+) and (-) of thebatteries must be correct).1. Slide Backwards3. Replace the cover until thelock snaps.Precaution on Battery UseIncorrect installation can cause battery leakage and corrosion that will damage the Remote Control Transmitter.Observe the Following Precautions1. Batteries must be replaced as a pair.2. Do not combine a used battery with a new one.3. Do not mix battery types (Example: "Zinc Carbon" with "Alkaline").4. Do not attempt to charge, short-circuit, disassemble, heat, or burn used batteries.-5-