Safety InstructionsCAUTIONCAUTION: To reduce the risk of electric shock do not remove cover or back. Nouser-serviceable parts inside. Refer servicing to qualified service personnel.The lightning flash with ar-_ row-head within a triangle _is intended to tell the userthat parts inside the productare a risk of electric shock topersons.The exclamation point withina triangle is intended to tellthe user that important oper-ating and servicing instruc-tions are in the papers withthe appliance.Note To CATV System Installer: This reminder is provided to call the CATV system installer's attention to Article820-40 of the NEC that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall beconnected to the grounding system of the building, as close to the point of cable entry as practical.Safety Instructions For Television Receivers1. Read and apply the operating instructions provided with your television receiver.2. Read all of the instructions given here and retain them for later use.3. Unplug this television receiver from the wall outlet before cleaning. Do not use liquid or aerosol cleaners. Use a dampcloth for cleaning.4. Do not use attachments not recommended by the television receiver manufacturer as they may cause hazards.5. Do not use this television receiver near water. For example: Avoid placing it near a bathtub, washbowl, kitchen sink, orlaundry tub, in a wet basement, or near a swimming pool, etc.6. Do not place this television receiver on an unstable cart, stand, or table. The television receiver may fall, causing seriousinjury to a child or adult, and serious damage to the appliance. Use only with a cart or stand recommended by themanufacturer, or sold with the television receiver. Wall or shelf mounting should follow the manufacturer's instructions,and should use a mounting kit approved by the manufacturer.6A. An appliance and cart combination should be moved with care. Quick stops, excessive force, anduneven surfaces may cause the appliance and cart combination to overturn.7. Slots and openings in the cabinet and the back or bottom are provided for ventilation, and to insurereliable operation of the television receiver and to protect it from overheating. These openings must not be blocked orcovered. The openings should never be blocked by placing the television receiver on a bed, sofa, rug, or other similarsurface. This television receiver should never be placed near or over a radiator or heat register. This television receivershould not be placed in a built-in installation such as a bookcase unless proper ventilation is provided.8. Operate only from the type of power source indicated on the marking label. If you are not sure of the type of powersupplied to your home consult your television dealer or local power company. For television receivers designed tooperate from battery power, refer to the operating instructions.9. This television receiver is equipped with a polarized alternating-current line plug (a plug having one blade wider than theother). This plug will fit into the power outlet only one way.This is a safety feature. If you are unable to insert the plugfully into the outlet, try reversing the plug. Ifthe plug should still fail to fit, contact yourelectrician to replace your obsolete outlet. Donot defeat the safety purpose of the polarizedplug.10. Do not allow anything to rest on the powercord. Do not locate this television receiverwhere the cord will be abused by personswalking on it.11. Follow all warnings and instructions markedon the television receiver.12. Do not overload wall outlets and extensioncords as this can result in fire or electricshock.13. Never push objects of any kind into thistelevision receiver through cabinet slots asthey may touch dangerous voltage points orshort out parts that could result in a fire orelectric shock. Never spill liquid of any kind onthe television receiver.EXAMPLE OF ANTENNA GROUNDING AS _PER (NEC) NATIONAL ELECTRICAL CODE _ _ ANTENNALEAD-INWIRE// _ J. pI ANTENNAJ / I "-_ J.. DISCHARGE UNrrI ELECTRIC / _ I] SERVICE _ _'_ _GROUNDING CONDUCTORS_......_ENT _'_ _ _EC SECTION 810-21)_ GROUND CLAMPS_ POWER SERVICE GROUNDING_._ ELECTRODE SYSTEM(NEC ART 250, PART H)-2-