Panasonic CT-2701 Owner's Manual

Contents

Panasonic CT-2701 Owner's Manual Manual pdf 7 page image

7ENGLISHANT(75 )IN OUTAUDIORL/MONOS-VIDEOVIDEOVIDEOAUDIORL/MONODIRECT CHANNEL SELECTION (0-9) - Press these buttons toselect a channel.The channel number will appear on the upperright corner of the TV screen. If an invalid channel number isselected, the display will revert to the previous channel.TV MODE DIRECT CHANNEL SELECTION - When the TV/CATV menu option is in the TV position, all channels can beinstantly selected by using two buttons (For example, to selectchannel 2, press "0", then "2". If you press only "2", channelselection will be delayed for a few seconds). For channels 10and above, press the 2 digits in order.TV - VHF/UHF channelsCABLE - CABLE TV channelsTo turn on the TV, press POWER.The VOLUME can be adjusted to a desired level bypressing VOL (VOLUME) B or A .The sound level will be indicated on the TV screen byGREEN BARS AND A NUMBER. As the sound levelincreases, so do the number of BARS AND THE NUMBERon the screen. The same is true for decreasing the level.Set the TV/CATV menu option to the appropriate position.When shipped from the factory, this menu option is in theCATV setting. See "To Memorize Channels".TV OPERATIONCATV mode direct channel selectionWhen the TV/CATV menu option is in the CATV position,channels can be selected as follows:1234 CH (CHANNEL) and Press and release the CH (CHANNEL) or . Thechannel automatically stops at the next channel set intomemory. Press and hold the button down to changechannels more quickly.For proper operation, before selecting channels, theyshould be set into the TV's memory. See "To MemorizeChannels".SETTING LANGUAGEThis TV can display the channel number, on screen displays and picture adjustments on the screen in English, Spanish or French.NOTE:If Spanish or French is chosen, the Closed Caption indicators will be in the selected language, but the Closed Caption text will notbe affected by the language selection.Press and then press or toselect desired language (e.g.English), then press ACTION.1234Press ACTION.Press B to select the SET UPmode, then press ACTION.Press ACTION to select the EXIT mode, then pressACTION again.CONNECTION TO OTHER EQUIPMENT (CONTINUED)If you connect a VCR with an S-video cable to the S-VIDEO jack on the rear of TV, you must also connect the audio cables tothe AUDIO IN jacks on the rear of the TV. The S-video cable only carries the video signal. Audio signal is separate.4. To connect the TV to a VCR with an S-VIDEO jackSet the TV/AV selection for this connection, to AUX1.NOTE: When the S-video cable and the video cableare connected to each jack at the same time,the S-video cable takes precedence over thevideo cable.NOTE: If the station being viewed stops broadcasting, the TVwill automatically shut off after 15 minutes.Rear of TVVCR(not supplied) AUDIO (R)AUDIO (L)(not supplied)NOTE:All four arrows can be used to selectthe SET UP mode, not just B.SET UPLANGUAGE/IDIOMA/LANGUEMODEAUTO PROGRAMMANUAL PROGRAMCC/ACTION: CABLE: OFF/ /PICTURELOCKEXITTIMERSET UPAUDIOLANGUAGE/IDIOMA/LANGUEENGLISHESPAÑOLFRANÇAIS/ACTION/1-910-1213-99100-125Press "0" twice, then 1-9 as needed.Example, to select channel 2, press "002".Press "0", then remaining 2 digits.Example, to select channel 12, press "012".Press the 2 digits in order.Example, to select channel 36, press "36".Press the 3 digits in order.Example, to select channel 120, press "120".