9Setup.Mode.Operations.(continued)4.Save.lens.file.to/load.lens.file.from.memory.cardPress..select.menu.number.[4].CAMERANo.DATASETDISPLAY SELECTUPDOWNSET UPND/CCM.GAIN/M.PEDSHUTTERNDM.GAINIRISM.PED10-19CCSHTSYNCSELECTEXECUTEEXITSAVE/LOADSHIFT+UP+DOWNSelect file number,Select y (Select)/n (Cancel)Save file indicationLoad file indicationPress to select themenu numberPress to exit setup mode(hold down)Press to confirmPress to save/load4-1.Save.lens.file.to.memory.card1..Press..to.select.[ND].•Each press of toggles between [ND] (Save) and[CC] (load).NDM.GAINIRISM.PEDCCSHTSYNC2..Press..or..to.select.a.file.number.on.the.memory.card.and.press..to.confirm.the.selection.NDM.GAINIRISM.PEDCCSHTSYNCTo save a file to file no. 2 on the memory card3..Press..or..to.select.[y].and.press..to.confirm.the.selection.•Do not remove a memory card that is being accessed.NDM.GAINIRISM.PEDCCSHTSYNC•To cancel saving, select [n] and press .•The file is saved to the memory card and [Fin] appears when savingends.•[E02] is displayed if the save operation to the memory card fails.(→page 13)If this happens, check the memory card and try again or insertanother memory card to perform the operation again.•[E01] is displayed when a lens file with the same name as the oneyou are attempting to save already exists on the memory card.To overwrite the file, press or to select [y] andpress .(→page 13)•[E04] is displayed when the lens file is off.•To exit setup mode, hold down for about 2 seconds.•To make other settings, press 4-2.Load.lens.file.from.memory.card1..Press..to.select.[CC].•Each press of toggles it between [ND] (Save) and[CC] (Load).NDM.GAINIRISM.PEDCCSHTSYNC2..Press..or..to.select.a.file.number.on.the.memory.card.and.press..to.confirm.the.selection.NDM.GAINIRISM.PEDCCSHTSYNCTo load file no. 2 from the memory card3..Press..or..to.select.[y].and.press..to.confirm.the.selection.•Do not remove a memory card that is being accessed.NDM.GAINIRISM.PEDCCSHTSYNC•To cancel loading, select [n] and press .•The file is loaded from the memory card and [Fin] appears whenloading ends.•[E02] is displayed if the load operation from the memory card fails.(→page 13)If this happens, check the memory card and see whether the fileexists on the memory card. If it does, start over from step 1.•[E04] is displayed when the lens file is off.•To exit setup mode, hold down for about 2 seconds.•To make other settings, press 5.Save.ROP.configuration.file.to/load.ROP.configuration.file.from.memory.cardPress..select.menu.number.[5].CAMERANo.DATASETDISPLAY SELECTUPDOWNSET UPND/CCM.GAIN/M.PEDSHUTTERNDM.GAINIRISM.PED10-19CCSHTSYNCSELECTEXECUTEEXITSAVE/LOADSHIFT+UP+DOWNSelect y (Select)/n (Cancel)Save file indicationLoad file indicationPress to select themenu numberPress to exit setup mode(hold down)Press to confirmPress to save/load
