10Setup.Mode.Operations.(continued)5-1.Save.ROP.configuration.file.to.memory.card1..Press..to.select.[ND].•Each press of toggles between [ND] (Save) and[CC] (load).NDM.GAINIRISM.PEDCCSHTSYNC2..Press..or..to.select.[y].and.press..to.confirm.the.selection.•Do not remove a memory card that is being accessed.NDM.GAINIRISM.PEDCCSHTSYNC•To cancel saving, select [n] and press .•The file is saved to the memory card and [Fin] appears when savingends.•[E02] is displayed if the save operation to the memory card fails.(→page 13)If this happens, check the memory card and try again or insertanother memory card to perform the operation again.•[E01] is displayed when an ROP configuration file with the samename as the one you are attempting to save already exists on thememory card.To overwrite the file, press or to select [y] andpress .(→page 13)•For details on Save/Load data, refer to page 6.•To exit setup mode, hold down for about 2 seconds.•To make other settings, press 5-2.Load.ROP.configuration.file.from.memory.card1..Press..to.select.[CC].•Each press of toggles between [ND] (Save) and[CC] (load).NDM.GAINIRISM.PEDCCSHTSYNC2..Press..or..to.select.[y].and.press..to.confirm.the.selection.•The file is loaded from the memory card and [Fin] appears whenloading ends. A few seconds later, the unit is restarted.•Do not remove a memory card that is being accessed.NDM.GAINIRISM.PEDCCSHTSYNC•To cancel loading, select [n] and press .•[E02] is displayed if the load operation from the memory card fails.(→page 13)If this happens, check the memory card and see whether the fileexists on the memory card. If it does, start over from step 1.•To exit setup mode, hold down for about 2 seconds.6.Format.memory.card1..Press..select.menu.number.[6].CAMERANo.DATASETDISPLAY SELECTUPDOWNSET UPND/CCM.GAIN/M.PEDSHUTTERNDM.GAINIRISM.PED10-19CCSHTSYNCSELECTEXECUTEEXITSAVE/LOADSHIFT+UP+DOWNSelect y (Format)/n (Cancel)Press to select themenu numberPress to exit setup mode(hold down)Press to confirm2..Press..or..to.select.[y].and.press..to.confirm.the.selection.•Card formatting starts.•Do not remove a memory card that is being accessed.NDM.GAINIRISM.PEDCCSHTSYNC•To cancel formatting, select [n] and press .•When the formatting ends, [Fin] appears.•To exit setup mode, hold down for about 2 seconds.•To make other settings, press 7.Select/set.flare.and.pedestalPress..select.menu.number.[7].CAMERANo.DATASETDISPLAY SELECTUPDOWNSET UPND/CCM.GAIN/M.PEDSHUTTERNDM.GAINIRISM.PED10-19CCSHTSYNCSELECTEXECUTEEXITSAVE/LOADSHIFT+UP+DOWNSelect FL (Flare)/PE (Pedestal)Press to select themenu numberPress to exit setup mode(hold down)Press to confirm7-1.Set.flarePress..or..to.select.[FL].and.press..to.confirm.the.selection.NDM.GAINIRISM.PEDCCSHTSYNC•To exit setup mode, hold down for about 2 seconds.•To make other settings, press
