Panasonic AK-HRP1005G Operating Instructions Manual

Also see for AK-HRP1005G: Operation guide Operating guide Operating guide Operating instructions Operating guide

Contents

Panasonic AK-HRP1005G Operating Instructions Manual Manual pdf 34 page image

Adjustment and settingsAuto SetupStarting auto setupBefore starting auto setupChoose [SYSTEM CAM] > [ASU MODE] in the ROP menu to select “FULL” or “EASY” mode.“ASU MODE” (see page 106)FULL Standard setup based on an outdoor shooting chartEASY Easy setup based on an outdoor shooting chartAlign the position of the gray scale wedge with the angle of view in the vertical direction of the viewfinder. Be sure to correctly select the pos-ition from which you shoot the chart since some positions may not enable a satisfactory auto setup.Recommended gray scaleStarting auto setupAA. [AUTO] buttonOperating procedure1. Assign auto setup to the [AUTO] button under [ROP SETTING] > [AUTO BUTTON] in the ROP menu.“AUTO BUTTON” (see page 112)2. Press the [AUTO] (A) buttonThe [AUTO] button flashes while the auto setup start preparation mode is established, and a square marker appears in the centerof the camera viewfinder. Align the white at the center of the gray scale with this square marker. (To cancel setup, press and holdthis button.)3. Press the [AUTO] (A) button again.The [AUTO] button lights as auto setup starts. (Holding down the [AUTO] button during the auto setup operation will abort autosetup.)The [AUTO] button goes off when auto setup ends successfully.If the [AUTO] button flashes at approximately 1-second intervals, auto setup has ended without being completed. Dur-ing the auto setup operation, the picture monitor (PM) displays characters to indicate operation status.If auto setup is not completed, check the message on the picture monitor (PM) on the CCU.- 34 -Adjustment and settings