Panasonic AK-HRP1005G Operating Instructions Manual

Also see for AK-HRP1005G: Operation guide Operating guide Operating guide Operating instructions Operating guide

Contents

Panasonic AK-HRP1005G Operating Instructions Manual Manual pdf 16 page image

ConnectionOperation ModesOperation mode setting procedureIn the factory default state, connect the CCU to the unit and then set the operation mode.Operation in IP connectionOperation in serial connection1. Configure the IP address of theIP connection device under[ROP IP SETTING] or[CAMERA IP SETTING] of theROP menu or via the Easy IPSetup Software.2. Configure the camerainformation to assign to eachcamera number under[CONNECT SETTING] of theROP menu or via the ROPSetup Software.3. Connect the CCU in IPconnection, and start operations.1. Set the CCU connection toserial connection under[CONNECT SETTING] of theROP menu.2. Connect the CCU, and startoperations.Connect the CCU to the unit in the factory default state.NOTEDo not start Easy IP Setup Software and ROP Setup Software during operation. The ROP will be disconnected, which in turn maycause a problem with operation.Switching between serial connection and IP connectionSwitch between serial connection and IP connection via the [CONNECT SETTING] settings of the ROP menu or via the serial/LAN settingsof the ROP Setup Software.“38 CONNECT SETTING” (see page 114)“ROP Setup Software” (see page 129)When the settings are initialized, the operation mode returns to serial connection (factory default state).“INITIAL with NW” (see page 113)Serial connectionSerial connection with the CCU ispossible.IP connection is not possible.IP connectionIP connection with the CCU is possible.A serial connection can be used incombination with IP connections.Switch to IP connection*1Switch back to serial connection*2Power ONWhen the settings are initialized, the mode returns to serial connection(factory default state).Factory default state*1: If an ROP configuration file that was saved to a memory card in IP connection is loaded in serial connection, the operation modebecomes IP connection.- 16 -Connection