Panasonic AJ-SPD850E Operating Instructions Manual

Also see for AJ-SPD850E: Parts list Operating instructions

Panasonic AJ-SPD850E Operating Instructions Manual Manual pdf 16 page image

16Control reference guide (continued)AC INSIGNALGNDAES/EBUCH1•2INCH3•4INCH1•2OUTCH3•4OUTSDIIN OUT123(SUPER)ACTIVETHROUGHANALOG ANALOGREMOTOYVIDEOINPBPRYPBPRONOFF75ΩREF VIDEOINONOFF75Ω123(SUPER)REMOTO INENCODER REMOTERS-232CCH1CH3CH1CH3CH2AUDIOINCH4CH2CH4AUDIOOUTDVCPRO/DV(OPTION)100BASE-TXTCINTCOUTMONLMONRSERVICE ONLYRear Panel (1/2)AC IN socketConnect one end of the power cord supplied to thissocket and the other end to the power outlet.DIGITAL AUDIO IN and OUT connectorsThese are the input and output connectors for digitalaudio signals that comply with the AES/EBU standards.ANALOG COMPONENT VIDEO IN connectorsThe analog component video signals are input to theseconnectors.ANALOG COMPOSITE VIDEO IN connectorsand 75 Ω termination switchInput connectors for analog composite video signals.A loop-through configuration is featured for each pair ofinput connectors.For termination at the memory card recorder, set theswitch to [ON].REF VIDEO IN connectors and 75 Ω terminationswitchInput connectors for reference video signals.Input a reference signal with color burst.For termination at the memory card recorder, set theswitch to [ON].Remote control connectorsConnect the memory card recorder to an externalcontroller.ENCODER REMOTE connectorConnect the memory card recorder to an externalencoder to adjust video output signal settings from anexternal component.Note:Video and audio output may be disturbed when thereference video signal is not input, so use a systemwhich inputs the reference video signal.Note:The digital audio signals must be synchronized withthe video input signals; otherwise noise will begenerated in the audio output signals.ANALOG AUDIO IN connectorsThese are the analog audio input connectors.TIME CODE IN connectorUse to record an external time code onto the cards.TIME CODE OUT connectorOutputs the playback time code during playback.Outputs the time code generated by the internal timecode generator during recording.SERIAL DIGITAL COMPONENT AUDIO andVIDEO IN and OUT connectors (optional)Installing an SDI interface board (optional board AJ-YA755G) in the memory card recorder enablesinput/output of digital component audio/video signalsconforming to the SMPTE259M-C standard.Video signals containing superimposed information canbe output through the SDI OUT 3 connector.To turn the superimposed information ON or OFF, usethe SUPER switch on the front panel.Note:The digital audio signals must be synchronized withthe video input signals; otherwise noise will begenerated in the audio output signals.