70 Using Play List: Audio Split EditingUse the following procedure to newly register an eventcontaining an audio split.◆ NOTE:• Refer to the “Revising Split points” section to add an audio split to aregistered event.1 Open the play list screen.2 Use the cursor buttons to choose the location whereyou want to add the event.3 Press the INSERT button.This activates the event register mode.4 Register an IN point.Use the operation buttons or search dial to look for alocation to start an event. Then hold down the IN buttonand press the ENTRY button.5 Register the audio split point.Use the operation buttons or search dial to look for alocation for an audio SPLIT point. Then hold down theSPLIT button and press the ENTRY button.6 Register an OUT pointUse the operation buttons or search dial to look for alocation to end an event. Then hold down the OUT buttonand press the ENTRY button.7 Press the EVENT button to end registration.◆ NOTE:• In the split display, “–” indicates forward while “+” indicatesreverse direction.• A split can be registered from the start of the original clip to theevent OUT point.• Set the IN point before the split point.• A SPLIT where the audio precedes the video cannot be madefor an event whose IN point is at the start of the clip.• When using the INSERT button to register a new event or usingthe EVENT button in a final event to register an event, register aSPLIT point before registering an OUT point as a new event willotherwise be registered.Registering From Video4,5,66 5 34217IN OUTClip APlay listEvent 02Event 01VideoAudioPossible audio split range
