Panasonic 2 Line KX-TG9541C Operating Instructions Manual

Also see for 2 Line KX-TG9541C: Quick guide

Handset / Base unit1 For line 1: MMENUN#3041For line 2: MMENUN#30422 MbN: Select the desired greeting message. aMSELECTN3 MYESN4 Proceed with the operation for your unit.Handset: MOFFNBase unit: MEXITNPlaying back the greeting messageHandset / Base unit1 For line 1: MMENUN#3031For line 2: MMENUN#30322 MbN: Select the desired greeting message. aMSELECTN3 Proceed with the operation for your unit.Handset: To exit, press MOFFN.Base unit: To exit, press MEXITN.Listening to messagesUsing the base unitWhen new messages have been recorded:– M N on the base unit flashes.– “New message: ” and/or “New message:” is displayed.For line 1: Press M N (PLAY1).For line 2: Press M N (PLAY2).R If new messages have been recorded, the baseunit plays back new messages.R If there are no new messages, the base unitplays back all messages.Operating the answering system duringplaybackKey OperationMDN or MCN Adjust the speaker volumeM N Repeat message*1M N Skip messageMPAUSEN Pause messageTo resume playback, pressM N.M N (Stop) Stop playbackKey OperationMERASEN Erase currently playing message*1 If pressed within the first 5 seconds of amessage, the previous message is played.Calling back (Call Display subscribers only)Press MZN during playback.R To edit the number before calling back, pressMEDITN repeatedly until the phone number isshown in the desired format (page 48).R The unit automatically uses the line you set inline selection mode (page 17) to call back.When the line selection mode is set to “Auto”,the indicated line ( or ) is used for the call.If the indicated line is already being used or youwant to select the other line, press MLINE 1N orMLINE 2N.R To call back using a cellular line, continue fromstep 2, “Making cellular calls”, page 27.Erasing all messages for the desired line1 MERASEN2 MbN: Select the desired line. a MSELECTN3 MbN: “Yes” a MSELECTNUsing the handsetWhen new messages have been recorded, “Newmessage” is displayed.1 To listen to new messages:For line 1: MPLAY1N*1, *2For line 2: MPLAY2N*1, *2orFor line 1: MMENUN#3231For line 2: MMENUN#3232To listen to all messages:For line 1: MMENUN#3241For line 2: MMENUN#32422 When finished, press MOFFN.Note:R To switch to the receiver, press M N.*1 If there are new messages in both lines,MPLAYN is displayed. Play the message asfollows:MPLAYN a MbN: Select the desired line. aMSELECTN*2 If there are no new messages in theanswering system, MPLAY1N, MPLAY2N, orMPLAYN is not displayed.56Answering System for LandlineTG9541C(en)_0723_ver012.pdf 56 2013/07/23 12:24:55