Panasonic 2 Line KX-TG9541C Operating Instructions Manual

Also see for 2 Line KX-TG9541C: Quick guide

Handset / Base unit1 Your headset:Set your headset to pairing mode.R Refer to the headset operating instructions.2 MMENUN#6213 If your headset PIN is “0000”, go to step 4.If your headset PIN is other than “0000”,press MCLEARN, then enter your headset PIN.R Typically, default PIN is “0000”. Refer tothe headset operating instructions.4 Press MOKN, then wait until a long beepsounds.5 Proceed with the operation for your unit.Handset: MOFFNBase unit: MEXITNR When the HEADSET indicator on the baseunit lights up, the headset is available foruse.Connecting/disconnecting a headsetIf you cannot connect the headset and base unitusing the headset, you can connect using the unit.To use your headset with another Bluetoothdevice such as a cellular phone, you may need todisconnect it from the base unit.Important:R Make sure that the headset is turned on.Handset1 To connect/disconnect:MMENUN#622R A long beep sounds.2 MOFFNBase unitTo connect:Press MHEADSETN.To disconnect:Press and hold MHEADSETN until a long beepsounds.Unpairing a headsetYou can cancel a pairing of the headset that isstored to the base unit.Handset / Base unit1 MMENUN#6122 MbN: “Yes” a MSELECTNR When the headset is unpaired, theHEADSET indicator on the base unit isturned off.3 Proceed with the operation for your unit.Handset: MOFFNBase unit: MEXITNOperating a Bluetooth wirelessheadset using a landlineImportant:R Refer to your headset operating instructions forheadset operations.Answering landline calls with your headsetTo answer a landline call, turn on your headsetreferring to your headset operating instructions.When you finish talking, turn off your headsetreferring to your headset operating instructions.Note:R If you cannot hang up the call using yourheadset, press MZN on the base unit 2 times.Switching between the base unit and yourheadsetYou can switch between the base unit and yourheadset:– during a landline call with the base unitspeakerphone.– during an intercom call between the base unitand handset.– while listening to messages recorded on thebase unit answering system.n To switch to your headset:Press MHEADSETN on the base unit.n To switch to the base unit:Press MZN on the base unit.Call sharing between your headset and thehandsetImportant:R To activate this feature, you should set privacymode to off beforehand (page 42).n While the handset is on a landline call:To join the conversation with your headset, turnon the headset referring to your headsetoperating instructions.52Using Bluetooth DevicesTG9541C(en)_0723_ver012.pdf 52 2013/07/23 12:24:55