Panasonic 2 Line KX-TG9541C Operating Instructions Manual

Also see for 2 Line KX-TG9541C: Quick guide

“Daily” An alarm sounds daily at the settime. Go to step 4.3 Enter the desired month and date. a MOKN4 Set the desired time.5 *: Select “AM” or “PM”. a MOKN6 MbN: Select the desired alarm tone. aMSELECTNR We recommend selecting a different ringertone from the one used for outside calls.7 MSELECTN a MOFFNNote:R To stop the alarm, press MOFFN or place thehandset on the base unit or charger.R When the handset is in use, the alarm will notsound until the handset is in standby mode.Night modeNight mode allows you to select a period of timeduring which the handset and/or base unit will notring for outside calls. This feature is useful for timeperiods when you do not want to be disturbed, forexample, while sleeping. Night mode can be setfor each unit.Important:R Make sure the unit’s date and time setting iscorrect (page 16).R If you have set the alarm, the alarm soundseven if the night mode is turned on.Turning night mode on/offHandset1 MMENUN#2382 MbN: Select the desired setting. a MSAVENR If you select “Off”, press MOFFN to exit.3 Enter the desired hour and minute you wish tostart this feature.4 *: Select “AM” or “PM”. a MOKN5 Enter the desired hour and minute you wish toend this feature.6 *: Select “AM” or “PM”.7 MSAVEN a MOFFNBase unit1 MMENUN#2382 MbN: Select the desired setting. a MSAVENR If you select “Off”, press MEXITN to exit.3 Enter the desired hour and minute you wish tostart this feature.4 MAM/PMN: Select “AM” or “PM”. a MOKN5 Enter the desired hour and minute you wish toend this feature.6 MAM/PMN: Select “AM” or “PM”.7 MSAVEN a MEXITNChanging the start and end timeHandset / Base unit1 MMENUN#2372 Continue from step 3 for handset or step 3 forbase unit, “Turning night mode on/off”,page 44.Call blockThis feature allows the unit to reject calls when:– the unit receives a call from a phone numberstored in the call block list as unwanted (“Storingunwanted callers”, page 44).– the unit receives a call without phone number(“Blocking incoming calls without phonenumber”, page 45).When a call is received, the unit rings for a shorttime*1 while the caller is being identified. If thephone number matches an entry in the call blocklist, the unit emits no sound to the caller, anddisconnects the call. (Call Display subscribers only)*1 This is called first ring. If you do not want thefirst ring to sound, turn this setting to “Off”(page 45).Important:R When the unit receives a call from a numberthat is stored in the call block list or a callwithout a recognized phone number, the call islogged in the caller list (page 47) with afterthe call is disconnected.R You can program this setting using either thebase unit or one of the handsets.Storing unwanted callersYou can store up to 250 phone numbers in the callblock list.44ProgrammingTG9541C(en)_0723_ver012.pdf 44 2013/07/23 12:24:54