OHAUS FD3 Instruction Manual

Also see for FD15: Instruction manual Service manual User guide Quick start guide Instruction manual

OHAUS FD3 Instruction Manual Manual pdf 17 page image

EN-11 FD Series3.4.2 Menu NavigationUse the four buttons marked with Yes, No, Back and Exit to navigate through the menus (refer toSection 3.2).• Yes - Enters the displayed sub-menu or menu item and accepts the displayed setting.• No - Skips to the next sub-menu or menu item and changes the displayed setting.• Back - Goes back to the previous sub-menu or menu item.• Exit - Immediately exits the Menu mode.3.4.3 Changing Menu SettingsEnter the menu by holding down theMenu button until Menu is displayed. When the button isreleased, the first available sub-menu is displayed.• Navigate to the desired sub-menu using the No button.• Enter the sub-menu using the Yes button.• Navigate to the desired menu item using the No button.• Enter the desired menu item using the Yes button.• Change the setting using the No button or accept the setting using the Yes button.• Continue navigation using the Yes, No and Back buttons or return to weighing using the Exit button.3.5 Application ModesTwo application modes are available in the FD Series: Weigh and Checkweigh. To enable theCheckweigh mode, Checkweigh must be turned on in the Mode menu (refer to Section 3.7.5).3.5.1 W e i g h i n gDetermines the weight of an item in the selected unit of measure. The FD Series is shipped withkilograms (kg) and pounds (lb) enabled. To enable other units of measure, they must be turned on inthe Unit menu (refer to Section 3.7.4).3.5.2 C h e c k w e i g h i n gUse this mode to compare the weight of an item to Under and Over target limits. When the checkweighmode is enabled, the “CHECK” indicator will turn on.To set the target limits, refer to Section 3.6 Checkweigh Target Settings.Place the sample on the weighing pan. If the sample weight is under the target weight range, theyellow LED will light. If the sample is within the target weight range, the green LED will light. If thesample is over the target weight range, the red LED will light. The LED indication is complemented byan audible alert feature (refer to Section 3.7.5).Normal CheckweighingSet both targets as positive values, where the lightest acceptable weight is entered as the Under targetlimit and the heaviest acceptable weight is entered as the Over target limit. Items placed on the panwill be compared to the targets.Visit www.balances.com to see the full line of Ohaus BalancesBuy your next Ohaus Balance online at https://scaleman.com/