OEM7®Installation and OperationUser ManualOEM7 Installation and Operation User Manual v1 42.8 Preparing the Data, Signal and Power Interface 272.9 Mounting the GNSS Antenna 312.10 Connecting the Antenna to the Receiver Card 322.10.1 Antenna LNA Power 322.11 Applying Power to the Receiver Card 332.12 Connecting Data Communications Equipment 332.12.1 Serial Ports 33OEM719 Multiplexed Port 34OEM729 RS-422 Port 35OEM729 Multiplexed Port 35OEM7700 Multiplexed Port 362.12.2 USB Ports 362.12.3 Ethernet Ports 382.12.4 SPI Ports 382.13 Test that the Receiver is Working 392.14 Installing NovAtel PC Utilities 39Chapter 3 OEM7 Receiver Operation3.1 Communications with the Receiver 413.1.1 Serial Ports 413.1.2 Communicating using a Remote Terminal 423.1.3 Communicating using a Computer 433.2 Getting Started 433.2.1 Starting the Receiver 433.2.2 Communicating with the Receiver 433.3 Transmitting and Receiving Corrections 453.3.1 Base Station Configuration 463.3.2 Rover Station Configuration 473.4 Configuration Notes 473.5 ALIGN Heading Master and Remote Configurations 483.5.1 Automatic Set Up for Direct-Wire Connection between Master and Rover viaCOM2 483.5.2 Manual Set Up via COM2 483.6 GLIDE 493.6.1 Dual-Frequency GLIDE 493.6.2 PDP and GLIDE Configurations 493.7 STEADYLINE® 503.7.1 Maintain 503.7.2 Transition 513.7.3 Prefer Accuracy 513.7.4 UAL 523.8 Enabling SBAS Positioning 533.9 Enabling NovAtel CORRECT with PPP 533.9.1 TerraStar Subscriptions 543.9.2 Veripos Subscriptions 553.10 RTK ASSIST 553.11 Transferring Time Between Receivers 563.11.1 GPS to Receiver Time Synchronization 563.11.2 Time Definitions 563.11.3 Procedures to Transfer Time 573.12 Interference Toolkit 613.12.1 Monitoring GNSS Signals 61Example: 61
