FCC StatementNote: This equipment has been tested and found to comply with the limits for a Class B digital device,pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection againstharmful interference in a normal installation. This equipment generates, uses and can radiate radiofrequency energy and, if not installed and used in accordance with the instructions, may cause harmfulinterference to radio communications. However, there is no guarantee that interference will not occur ina particular installation. If this equipment does cause harmful interference to radio or television reception,which can be determined by turning the equipment off and on, the user is encouraged to try to correct theinterference by one or more of the following measures:Reorient or relocate the receiving antenna.Increase the separation between the equipment and receiver.Connect the equipment into an output on a circuit different from that to which the receiver isconnected.Consult the dealer or an experienced technician for help.A shielded cable must be used when connecting a peripheral to the serial ports.Industry CanadaOperation is subject to the following two conditions: (1) this device may not cause interference, and (2)this device must accept any interference, including interference that may cause undesired operation of thedevice.IMPORTANT SAFETY INFORMATIONPlease read carefully before installation and use.DANGER This is the safety alert symbol. It is used to alert you to potentialpersonal injury hazards, Obey all safety messages that follow this symbol toavoid possible injury or death.! WARNING WARNING indicates a potentially hazardous situation which, if not avoided,could result in death or serious injuryCAUTION! CAUTION indicates a potentially hazardous situation which, if not avoided, couldresult in minor or moderate injury.CAUTION CAUTION used without the safety alert symbol indicates a potentiallyhazardous situation which, if not avoided, may result in property damage.DISCLAIMER: It is the owner’s sole responsibilityto install and use the instrument and transducersin a manner that will not cause accidents, personalinjury or property damage. The user of this productis solely responsible for observing safe boatingpractices.BRUNSWICK NEW TECHNOLOGIES INC. AND ITSSUBSIDIARIES AND AFFILIATES DISCLAIM ALLLIABILITY FOR ANY USE OF THIS PRODUCT IN A WAYTHAT MAY CAUSE ACCIDENTS, DAMAGE OR THATMAY VIOLATE THE LAW.Governing Language: This statement, any instructionmanuals, user guides and other information relatingto the product (Documentation) may be translatedto, or has been translated from, another language(Translation). In the event of any conflict betweenany Translation of the Documentation, the Englishlanguage version of the Documentation will be theofficial version of the Documentation.This manual represents the Explorer 650 as at thetime of printing. Brunswick New Technologies Inc.and its subsidiaries and affiliates reserve the right tomake changes to specifications without notice.Copyright © 2006 Brunswick New Technologies Inc.Northstar™ is a registered trademark of BrunswickNew Technologies Inc